Hi, can some one please tell me if there are more than 1 sensors on a Hyundai trajet auto 2001,crankshaft, as Iv heard sensor,angle sensor,and positioning sensor,as I don't wont to buy the wrong one, Thank you.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Those sensors are usually located somewhere near the actual crankshaft pulley. You might need to remove the covers over the timing belt to get to it. The photo below is only a guide for general appearance and position.
It appears that another Hyundai owner had the same problem and sorted it out himself. U0D00 seems to be the Mass Airflow meter (sensor). Replace it and see how it performs. Good luck.
This sounds to me like an intermittent crankshaft sensor problem. Did your CHECK ENGINE light come on? Crankshaft sensors sometimes flicker this way before they completely die, sometimes they don't. I think you may have a flickerer. Have the code checked at your local Advanced Auto or Auto Zone. The part is only about $30.00. GOOD LUCK.
could be a bad crank sensor, a bad crank sensor will let car run for a while then shut down and will not start for 10 to 15 min. and it will repeat this cycle if not fixed.the crankshaft position sensor provides the ignition module and pcm with a crankshaft position signal. the module uses this signal to determine spark for each cylinder. the pcm uses this signal for proper timing of engine.
it is inside the timing cover in most cases with hyundai the timing belt will have to be removed so the crank gear can come off the sensor is usually behind the gear especially if it is a 6cyl if it is a 4 cyl then the wire goes behind the timing belt make sure the timing marks are lined up so when you reassemble it is lined up
Priced new output speed sensor €190, went to breakers yard, found similar sensor on mitsubsihi carisma, purchased €20, fitted same no problems since. Touch wood!
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
×