My 99 hyundai elantra back driver side window is stuck in the down position is their a way to release it up and keep it up

There are two fuses that cover the power windows, but if it is only one window, it is likely to be the switch, the wiring, or the motor on that particular door. An auto-electrician can diagnose. Videos may help.

Hyundai Elantra (XD; 2000-2006) fuses and relays

Fuse-Box.info https://fuse-box.info > hyundai > hyundai-elantra-xd-...

The fuse box is located on the driver's side of the instrument panel behind the cover. The location of the fuses in the passenger compartment: Hyundai Elantra ( ...

Power windows stopped working. : Hyundai Elantra ...

repairpal.com > Problems > Hyundai > Elantra
Hyundai Elantra power windows goes down , but does not want to go up. ... Now I can only open it using the drivers side control and close it using only the passenger side control. ... Just the rear passenger window doesn't work. ... All of the windows in the car except the front driver side window had stopped working.

How To Fix A Slow Power Window - YouTube

? 2:32
www.youtube.com/watch?v=BRi5Wq1OgmY

Mar 7, 2011 - Uploaded by Nthefastlane
Click here: https://rdy.cr/f7a3a1 How to fix slow power windowsthat get ... technician finds the true problem. that doesn't mean every mechanic is a ... Like it shifts towards the front of the car and leaves a 1/2 inch open .... I have an 09 Toyota Rav4 and had a little shutter on the last 1/4 of the window closing.

Hi,
The window scraper seal has been dislodged from its position, those white pins that you see are the locking pins that holds it down into position. If that is the one you replaced better bring it back to the shop that installed it. Plastic clips/pins might already broken.
Installing it without any experience in opening the inside mechanism of the door/window will vodi the warranty of the works that have done to it.
Placing it back, you have to remove the door cover, window regulator, wiring harness, and window glass. Just to get that small thing back into position.
Hope that helps you out.
Thanks fro asking FixYa!

Same thing happened with mine. It turned out that the power door lock motor went out. Since the handle or the switch can unlock the driver's door, both of these mechanisms are connected. When the door lock motor goes out it freezes in whatever position, it was last engaged.

could be the driver side master window switch... if the driver side window switch assembly is broken then the windows will not work... try using a test light to see if you got power to the with and and ohm meter to check all four switches on the drivers side

If you remove your door panel, and look at the guts of the window mechanism, you'll find a motor that should move the window up and down. The gear on the motor is probably either stripped, displaced, or the window regulator (the other half of the system)'s gear teeth are similarly damaged/displaced.

If you visit many forums for Elantras, you will see that frequent headlamp failure is very common. It has been discussed over and over again and it is thought that always turning the lights off and on via the stalk switch is recommended. If you leave the light switch in the on position, when you start your car, the lights briefly flash on then off again as you turn your ignition to the start position and then turn on again as you release the key to return to the "on" position. This may be causing a power surge which creates stress on the bulb filament and can only be avoided by using the light switch instead of the ignition to power up the headlamps.

With the engine running........push up on the window switch and WHACK the door hard.....repeated WHACKS may be necessary.....it should go back up.
Do not put it back down.

check timming belt it has jumped a notch

Try switching the power window switch from the passenger side to the drivers side. Before you do that try with the switch on the up position, wiggle it from side to side. The contacts may be worn and by wiggling it may make contact. Other then that try to park it in side or garbage bag taped to keep rain out till you get it to the shop.
Hint, take it to a Auto window repair shop to replace the switch if it's bad or if the motor is bad. They have more experience to removing the door panels and removing the power window regulator (motor) if that needs to be replaced.
Good luck and hope this helps.