Cars & Trucks Logo

Related Topics:

Anonymous Posted on Aug 30, 2009

Wants to start spits and sputters but wont start! the car was running when it died and wont start back up! is getting gas has spark it turns over! any suggestions on what to check or what it could be?

1 Answer

Craig Butler

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 1,730 Answers
  • Posted on Aug 30, 2009
Craig Butler
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Jun 26, 2009
Answers
1730
Questions
0
Helped
697649
Points
4778

You don't say what year so I have no way of knowing if you have a distributor? If you do, pull the cap and look at the rotor and inside cap contacts that go to plugs. Make sure the rotor is not all burned up looking and the cap is good too./ Push all plug wire and cap wires on tight and start with that. Let me know some more info....Is it a electronic ignition Distributorless ignition system, fuel injection or carb?

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

My 2000 park avenue starts fine but once it warms up it spits and sputters then dies and it wont start

If it is backfiring and dying I would be willing to bet you have a crank angle sensor going out when it get warmed up. Also check to see if your fuel pump is running by listening in the gas door with the cap off. I have had them do this when the fuel pump gets hot it quits pumping fuel.
0helpful
2answers

My 1999 blazer spit sputtered and then died turns over then acts like it timing jjmped well with new timing chain still doing this any ideas

Go back to basics, spark and gas getting to the cylinders? Does the engine crank at normal speed for cranking? If so, check spark and gas. If it's in time, it must have lost one or the other.
One easy way to check, spray some stating fluid into the air intake (take off the large boot) and try to start. If it runs or almost starts on the fluid, you know it's a gas problem. If it doesn't fire at all with the fluid, it must not be getting spark. Then you check out or test the ignition system.
0helpful
1answer

What do these codes mean on a diagnostics check? c, ev, o, oh,e? what are these numbers for ISO9141 KWP2000 and why does it steady blink on monitor then say backfire problems?

you need to read the manual for the machine you are hooking to the vehicle .
These are errors not codes you need to understand how it works better.
0helpful
1answer

Have a 87 buick lesabre 3.8 liter motor. Having trouble with it starting. Acts like not enough fuel or spark. Sometimes it takes 3 times cranking on the starter to get it to start. Also when it gets hot...

Please check the following.

Check Spark at the plugs. (all of them)
Fuel filter not clogged.
Choke working properly.
Rev the engine while shooting carb cleaner through all the ports.
pull and clean and check your mixture screws. (Remember to EXACTLY count the turns out and go back in the same). See if this helps. Mike
0helpful
1answer

Truck will not start

remove coil wire at distributor and plug a HEI GM tester spark plug to see if spark at ignition coil if not test ignition coil for current and signal not short to ground
0helpful
2answers

Backfire, Black smoke from exhaust, spitting and sputtering

If you have not replaced plugs start there A bad map sensor will also cause black smoke and poor running
1helpful
1answer

I got a 1998 jimmy with the 4.3 vortec. Engine my wife was driving it when all of a sudden it started to spit and sputter and die out it would start up fine and idle great but as soon as you go to push the...

This could be a blockage in the carburator,try to clean it, especially the valves. There is a specific spray for the job on the market. You might need to dismantle it.
wurth-dvozx1blhoqooxyg5xkss51j-5-0.jpg
1helpful
1answer

Power steering belt came off cant put back on because the top pulley is loose, the vehicle will not start anymore it was running ok then it spit and sputtered and died, it will crank but won't turn over...

Broken wires to fuel pump and little rodent of some kind chewed thru it. the power steering pump shaft was broken so it got fixed cost about $450 parts and labor!
0helpful
2answers

Car dies when you step on gas

have the fuel preasure checked may not have enough preasure, the car will start but will shut down when trying to accel, good luck.
1helpful
1answer

Sportage won't run

no spark but 12v at coils
Not finding what you are looking for?

147 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...