ABS light intermittenly comes on and off??

LOW OIL CHECK THE DIPSTICK

with these lights on then you will have to see what codes are in the abs and pcm module to find out what the problems are.the abs module will activate when the traction control lights come on.this can also cause a noise and pulsate in the brakes pedal.

Hello,
There is a ground wire connected to the engine block. Look for it on the back passenger side of the engine towards the top. Remove it and clean the connection and the wire connector and replace. Sometimes they get real bad and throw the ABS light on. Sometimes a brake light out can throw the ABS light on.

• You said you rebuilt the ABS module, do you have a short in it you are missing? The bulletin for this originally suggested to replace the module and was corrected because the ground itself was the major offender.
• Try to reground the EBCM. The code 0265 says "loss of communication with the brake module" The EBCM Ground is located on the frame beneath the driver's side door. If multiple grounds are found in this location, the EBCM ground can be identified as the heavy (12-gauge) wire. Clean the area, front and back, using a Whiz Wheel.

• Install the ground, then the washer and then the bolt to the frame. Important: It is important to use the bolts, washers and nuts specified in this bulletin. These parts have been identified due to their conductive finish.
• Install a washer and nut to the back side of the frame.
• Tighten the nut to 9 N·m (79 lb in).

• Cover the front and back side of the repair area using Rubberized Undercoating. An additional check can be made to ensure a good connection for the Battery Cable to Frame ground.

Regards, Tony

When the ABS light is on the ABS system is deactivated. Meaning, when the abs is light is on and you brake, the tires will lock up with heavy braking.

Escapes have a common issue of the ABS excitor rings cracking causing ABS problems. Sometimes it activates on almost every brake application. It may set a code in the ABS computer for an intermitten wheel speed sensor or no wheel speed signal. Check all the "rings" on the outside of all four axleshafts. If none of the rings are cracked it is likely a bad ABS wheel speed sensor.

I would have a brake tech at a reliable auto center check the abs (anti-lock brake system)
Do you have any lights on in your dash with the letters abs ?
I would have this checked out now. It is not safe to drive your vehicle if there are brake problems, no matter how " intermitten"
Please let me know what you find.

i was driviing my '97 volvo 850glt ---it just died, i tried to start it again but it will turn over but not start any thoughts ?

I had a similar situation and it was my wheel bearings.

you may need to have the wheel bearings replaced. if its front wheel drive then the front, if rear wheel drive then the rear, if all wheel drive.....

check the abs rings on the axles they have a tendency to crack and will set a light. does the vehicle have remote start? Is it an aftermarket system?

there is a problem with one or both of the systems the esc uses brakes to correct positioning of car the abs detects wheel lock up unfortunately it needs to go to the scanner to see which system coded first