I have a 2001 Acura Integra,the maintenance

maintenance light is for service needed only, i.e oil change, air filter change needed. E-brake light may indicate low brake fluid. To reset the maintenance light folow this >>>> 1.with engine OFF, press and hold odometer reset/select button(near speedometer). 2. Start the vehicle(still press and holding button) 3. while pressing and holding w/engine on wait 10-15 seconds (light should blink and may dissappear).4.Shut engine off and release the button. 5.restart engine and light should be OFF. As for the brake fluid, open your hood and check the fluid resevoir for proper fluid level. This resevoir is mounted to a large black circle object on the back driverside of the engine compartment. Refill if necessary. If levels are good, you may have a faulty E-brake switch. If it is low, refill and have the braking system checked for fluid leaks immediately, this could cause brake failure. Hopefully this helps

The process of turning off the maintenance requested light is a little different for each Acura/Honda Its usually in the owners manual. It involves holding the trip meter button on the gauge cluster and then turning the ignition half way on for a certain amount of time. To get rid of the e-brake light its probably the sensor underneath the center console. You just need to remove the center console to gain access to the switch. Then play around with the switch a little bit until you figure out why its staying on. While your in their looking at the switch you might as well adjust your ebrake by tightening the screw thats inline with the cord to the rear brakes.