Shows a PO340 camshaft postion sensor code. Have replaced sensor, but problem is still there. Engine turns over after it dies, but will not start
Wiring problem or the ECU (engine control unit) is defective. Try this, disconnect the battery cables from the battery and short/touch them together for 30 seconds (do not do this if connected to the battery). Then, reconnect the cables to the battery posts & see if that fixes it. If it doesn't, then there is a wiring problem associated with the cam pos snsr or the ECU has gone bad.
686 views
Usually answered in minutes!
did you check your timing? If it is off even 2 teeth it will set that code.
×