When I switch the engine off, the clock does not

There is no fuse, but try Relay No. 4. You may need an auto electrician if that doesn't work.

Fuse box diagram Volkswagen Golf 3 and relay with ...

https://fuseandrelay.com > volkswagen > golf3 It is located at the bottom of the dashboard on the driver's side, behind the protective cover. To remove it, press the buttons - latches. Block access.

1991-1997 Volkswagen Golf Mk3 Fuse Box Diagram

https://knigaproavto.ru > shemy > 45-volkswagen-golf-... Jun 11, 2016 - Fuse Box Diagram Volkswagen (VW) Golf 3 - 1.4, 1.6, 1.8, 1.9, 2.0, 2.8, 2.9 L. (1991, 1992, 1993, 1994, 1995, 1996, 1997)

Volkswagen Golf mk3 - fuse box diagram - Auto Genius

https://www.autogenius.info > volkswagen-golf-mk3-fu...
Jul 12, 2015 - Fuse arrangement according to the numbers on fuse panel from left to right) ; 17, 10, Emergency flashers ; 18, 20, Fuel pump, oxygen sensor heater.

Here is a very helpful link to a wiring diagram for your VW's fuse box.

Wiring Diagram for CE2 vehicles

I hope that this helps!

Here you have the ignition diagram for a mk3 1994 VW Golf 1.6 ABU engine code:

you have just found this out.it is a standard feature of all vw/audi/seat/skoda cars
unlock/hold key over,the windows will go down
lock/hold key over the windows will go up
then unlock the car with the remote,car reset.
sit in car with engine on,switch off engine(do not open any door)driver can open/close any window(you can even put your hand into window frame and it will rollback,all on its(not for fun)
if windows rollback after you have used button to close them you may have sticky runners/rubbers.
this is not in the hand book,tell all your friends.....only a german car.....

Try boot lock

vw mk3 vr6 instrument cluster

hi i have the same problem.but i cat find what to do.iff u eill find out please le me know.07853592087

www.ebookmanual.net/vw-golf-jetta-service-and-repair-manual.html

i had the same problem. After checking the window motor was not the problem i then checked the wiring harnes in the door. I beeped out all the connectors to make sure there were no broken wires and cleaned up all the contacts. The main connector looked quite corroded. I sprayed all the connectors with rust check and reassembled. The window is working fine now

Hi

One major cause of a hot engine cutting out is crank sensor failure. The sensor overheats, the engine cuts out, and then once everything cools back down the engine will start and run again.

Another possible cause is the O2 sensor.

A live scan would show up any problems.

Regards

Geordie