Question about 1999 Toyota 4Runner

Open Question

I need a wiring diagram for 1999 Toyota 4 runner driver side door with automatic windows and locks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: driver side door lock

Pull the door panel & replace the electronic lock solenoid.
Not easy, but this is what you need to do.

Posted on Sep 09, 2008

Ad
  • 261 Answers

SOURCE: Driver side door lock stopped working

sounds like the lock motor is locked up or probably broken connectors yo have to open the door panel to check this out.

Posted on Nov 14, 2008

  • 1 Answer

SOURCE: 2004 Jeep Grand Cherokee driver side power windows do not work

I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Posted on Dec 07, 2008

  • 2 Answers

SOURCE: replace front brake pad 2003 toyota 4 runner

Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers

Posted on Mar 25, 2009

  • 184 Answers

SOURCE: How to reset the ''Check Engine'' light on a 1999 Toyota 4-Runner?

http://www.obd-codes.com/faq/reset_obd_codes.php

Posted on Apr 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 Toyota 4-Runner. The keyless alarm has stopped working on the drivers side door.


On the driver side the actuator is more likely the culprit,the linkage could of come off or the actuator just doesnt work

Mar 06, 2012 | 2003 Toyota 4Runner

2 Answers

Power door locks for 1999 toyota 4runner unlock but do not lock on inside switches or remote


I have the same problem I can unlock my toyota 99 4 runner but does not lock on inside switches or remote.

just found out about it today.

Feb 16, 2010 | 1999 Toyota 4Runner

1 Answer

Spark plug wiring on 2001 Toyota 4 Runner, need a diagram to know which coil on the passenger side hooks to which plug on the drivers side.


1st coil goes to 2nd plug on lh side
2nd coil goes to 3rd plug on lh side
3rd coil goes to 1st plug on lh side

Feb 07, 2010 | 2001 Toyota 4Runner

1 Answer

Camry 1996 automatic power lock doen't work, but windows work.


if you can here relays when unlocking/locking check for power at door lock actuators inside doors, if you have power on lock/unlock and good earth from connector actuators are faulty.
if no power on test light when operating check output from central door lock module while operating, none coming out of module then it might need replacing.
check 30Amp power fuse for main relay under bonnet (which goes to pin 8 white/blue on module)and 10Amp gauge fuse in cab(pin 1 blue/red on module),pin 15 is also power when relay is on(red/blue) with test light, and module/ actuators.
check outputs from module pin 3 & 4
blue/red
blue/black
that go to door locks

Jul 20, 2009 | 1996 Toyota Camry

1 Answer

Remove a driver side door panel on a 2000 Toyota Limited 4 Runner


remove the screws that hold the inside door handle and clips behind the door panel

Jun 14, 2009 | 2000 Toyota Corolla

2 Answers

1999 Toyota Camry door lock and unlock issues


I believe this was done as a safety feature. It stops a potential car hyjacker from sneaking in the passenger door when you open the driver door. I know recent Hyundai models are set up such that if you turn the key in the driver's door once it only unlocks the driver's door. If you turn it twice in quick succession it unlocks all of the doors. Maybe the Camry is set up the same way.

Jun 03, 2009 | 1999 Toyota Camry

1 Answer

Camry 1999 power windows and door lock didn't work


did you check the relay under the hood ? look and see if you can find your power box under the hood and under the lid of that box you will find the location of the window relay check that first before tearing into the door panel switches .. thanks Jerry and holler if you need more

Apr 12, 2009 | 1999 Toyota Camry

1 Answer

My electric windows and automatic seat belt do not work


Its time to stop being afraid of the unknown. there is no doubt that you will need to remove the inner door panel to access the electrical modules behind the buttons. https://www.youtube.com/watch?v=p2_f7NkjH8E hope this helps.

Oct 13, 2017 | 1989 Toyota Camry

Not finding what you are looking for?
1999 Toyota 4Runner Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85108 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...