Question about 2000 Dodge Ram 1500 Truck

1 Answer

2000 dodge 1500 passenger van showing abs codes 36, 71, and 72. check engine and check gauge lights are on and oil pressure gauge reads 0 so I had oil checked and the oil is fine? what am I dealing with exactly?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Dodge Master
  • 1,369 Answers

Thats an electrical problem.

Posted on May 16, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Low Oil Pressure on 1992 Chevy 1500 Pickup Truck

1992 silverado pickup has a problem with the oil pressure Gage on the dash board fluctuate when i put break on or accelerate the gas 

Posted on Feb 14, 2009

  • 1201 Answers

SOURCE: 4.7 liter oil pressure gauge malfunctioning.

Check or replace the oil pressure sending unit.

Posted on Feb 25, 2009

  • 38 Answers

SOURCE: Come to stop 99 Ram oil pressure drops to 0 check gauges light.

Change the oil! The 318Cu in V8 (5.2 liter) engine has a problem with sludge build up on the oil pump pickup tube screen. This engine requires oil changes at or before 3500 miles with a high detergent oil.

Posted on Jul 07, 2009

  • 295 Answers

SOURCE: oil pressure gauge goes up when car started, but then down to 0

u Have a problem with the oil sending unit. The sensor is located beack right side of the engine block. Take out the switch and make sure u have good oil PSI. Should be 6 psi at idle and around 50 at 4000 RPM. If the presure is ok replace the switch they are very cheap about 20 bucks. Please rate.

Posted on Aug 12, 2009

  • 434 Answers

SOURCE: 2004 Dodge Ram 1500 5.7L at start up check gauge

Sounds like the oil pressure sending unit needs replaced.

Posted on Apr 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4x4. abs code says 36,71,72. Any ideas what these codes are?


36 no signal from rear sensor
71 control unit random access memory malfunction
72 control unit read only memory malfunction

May 05, 2016 | 2000 Dodge Ram 1500 Truck

1 Answer

My check engine light came on and oil gauge reads zero. DTC code is P0523 "engine oil pressure switch/high voltage. Do I just need to replace the pressure switch?


was it at 0 while it was running, did you check the oil? i wouldn't start drive it like that without being sure its still pumping oil...

May 22, 2014 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

I just purchased a 2000 GMC Savana 3500 with the 5.7 litter engine with 92000 miles on it. The temp gauge shows that the engine is running between 100 - 160 degrees, seems too cold. The oil pressure gauge...


you probably have your finger on the problem. have oil pressure test .when engine hot minimum 12psi.and change the thermostat.Don't cost much

Sep 16, 2013 | 2000 GMC Savana

1 Answer

Oil light flickering 2010 Dodge Ram 1500


If the oil pressure gauge is showing good oil pressure, I would check the switch for the warning light.

Apr 12, 2013 | 2010 Dodge Ram 1500

1 Answer

"Check your gauges" light come on when I come to a


you are low on oil in the engine- brake hard and watch the pressure gauge it will drop also---you are at least 3 qt's low.

Jan 01, 2011 | 1998 Dodge Ram 1500 4WD

1 Answer

2004 Doge Ram 2500 5.7 Hemi 190K mile had oil pressure gauge drop to ZERO and check gauges light come on and engine shut down.. Check oil 1 guart low, add oil. let cool. crank up, good gauges drove home 45...


If the valve lifters are quiet you most likely have oil pressure even with gauge showing "0".Sounds like the oil pressure switch going bad.I would try that first.

Apr 28, 2017 | 2004 Dodge Ram 2500

2 Answers

Change the iac on a dodge ram b3500 van and still have the p0505


the idle air control is on the back of the throttle body. it has a plug going to it and is held to the throttle body with 2 screws

Oct 08, 2009 | 2000 Dodge Ram 3500

1 Answer

4.7 liter oil pressure gauge malfunctioning.


Check or replace the oil pressure sending unit.

Feb 25, 2009 | 2005 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

84619 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...