Question about Honda Cars & Trucks
Check the turn signal and brake light bulbs. These older cars were wired so that when a bulb failed, the turn signal failed to work. Also check the signal relay, it might have gotten tired and needs replacing.
Posted on Mar 16, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 1988 honda accord turn signal
Mine did the same around 200K. Near the hood release handle is the fuse panel with the flasher relay. Remove the panel on the lower dash marked "FUSE" which gives you a viewing window to see the fuse panel which you reach from below the dash to access. Simply place your hand on one of the two 1" wide metal cylinders on the fuse panel(these are the relays) and turn on the left or right blinker. Feel for a click. If you feel a click but it is not constant, YOU FOUND THE DEFECTIVE RELAY!!! (Use the same test to find your Emergency flasher relay) Replace the on that does not work.
Posted on Apr 13, 2009
First drain radiator by opening drain valve,"located on bottom corner usualy the right,but not always." If you open the overflow or remove cap this will happen much faster.For safety sake disconnect ground wire from battery,the radiator is locked down by top cover that attaches to body with generaly 4 bolts, upper and lower hoses have to be disconnected and if it is automatic the transmission cooling lines are connected in stacked fashion,"one above the other."The cooling fan has to be unplugged and it should be removable at this point,"when unplugging fan be carefull with connector so it doesn't break.reverse steps to replace making sure the bolts go in the right place and it all fits properly.the thermostat,"located behind the kneck of upper hose," should be replaced after connecting lower hose because in order to fill the block up and prevent damaging thermostat the block shoud be filled with coolant before attaching upper hose.
Posted on Apr 20, 2009
inside the handle there is ONE screw covered by a piece of plastic. remove the plastic and then remove the screw. pull handle out and disconnect it from the door latch bar. replace in reverse
Posted on Oct 11, 2009
Tips for a great answer:
Jan 27, 2017 | 2005 Honda Accord
Dec 25, 2014 | 1997 Honda Accord
Oct 01, 2010 | 1997 Honda Accord
Aug 18, 2010 | 1990 Honda Accord
Oct 13, 2009 | 1997 Honda Accord
Jun 08, 2009 | 1997 Honda Accord
May 09, 2009 | 1997 Honda Accord
Mar 20, 2019 | Honda Cars & Trucks
26 people viewed this question
Usually answered in minutes!