Question about Chevrolet Equinox
One ugga dugga should suffice. Make sure you use lock tight to prevent them from coming loose though.
Posted on Mar 01, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
normally 110 nueton metres. use nut lock and once you have torqued you will feel if you have to tighten it a bit more.
Posted on Aug 15, 2008
Step one 37 ft lbs then tignten 120 degrees more
Step one 11 ft lbs then tighten 90 degresss more
89 inch lbs
132 inch lbs
Posted on Dec 02, 2008
SOURCE: need torque specs
Valve Rocker Arm Bolt 19 N·m + 30° (14 lb ft+ 30°)
A GM dealer shows me another source, which says 32 Nm (24 lb-ft). Not sure which one is right but they screwed up my car.
Posted on Mar 17, 2009
1.Flywheel - 61 to 69 Foot Pounds
2.Pressure Plate - 25 to 33 Foot Pounds
3.Bell Housing - No specs found. I would say 25 to 35 foot pounds should be sufficient.
Bolts clean on ->flywheel to crank, ->pressure plate to flywheel, and ->bell housing to back of engine, I would use TWO drops of Loctite Red threadlocker, on ALL of these bolts.
Hope you have an alignment tool for your clutch disk when you install it. Auto parts stores sell the plastic one's cheap! Saves a LOT of headaches!
Tighten the pressure plate EVENLY! Snug the bolts down until they just TOUCH, then go in a criss-cross pattern when tightening. Do the tightening in incremental stages! You turn one bolt one thread, you go across to the opposite side, and turn that bolt one thread. Keep criss-crossing so the pressure plate goes down EVENLY. (YES, it's a pain in the keister!)
If NOT, you'll have a warped pressure plate, and it will be junk!
Thanks for letting me say that, I feel better.
Posted on Jul 07, 2009
99 chevy malibu v6 3.1 engine, head bolt torque is-- 98 through 2001 is step1- 37 foot lbs, step 2- rotate an additional 90 degrees (1/4 turn). the rocker arm bolts are 168-in. lbs.
Posted on Sep 07, 2010
Tips for a great answer:
Dec 09, 2016 | 2005 Chevrolet Equinox
Oct 28, 2016 | Chevrolet Cars & Trucks
Sep 26, 2016 | 2010 Chevrolet Equinox LS
May 02, 2014 | Cars & Trucks
Mar 14, 2013 | 2006 Chevrolet Equinox LT
May 12, 2011 | Hyundai Accent Cars & Trucks
Oct 03, 2010 | 1982 Chevrolet El Camino
Mar 24, 2010 | 1989 Ford Bronco II
Jan 15, 2010 | 1984 Chevrolet Chevy
88 people viewed this question
Usually answered in minutes!