Televison & Video Logo

Related Topics:

Have lg 50pc5d plasma the front panel light is red.i press the power button and the light turns green. but no picture and no sound.

With the back removed there are 4 led lights on the logic board, positioned in a row and are labeled D2,D3,D4,and D5 that light randomly at startup and sometime remain lit but never all at once. any help is appreciated

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Nov 29, 2008

SOURCE: Engine runs really hot, and engine light comes on while in D4

I had the same problems with my Acura Legend. On the problem with the running hot and the idling up and down, your cooling system is low. Fill your cooling system start it up and look for leaks, steam, or etc. repair and refill and your problem should be cured if the cooling system is full. At this time i'm working on the other problem. Good Luck

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Dec 12, 2008

SOURCE: Gear Position light D4 is always flashing irrespective of gear.

This issue is caused by a transmission fault or malfunction, most likely a shift solenoid in the trans has failed or the trans control module has a problem, the trans can be tested for codes that will show what circuit or component of the trans controls is causing the light to stay blinking, have it tested.

mecanica03

ROBERT GARCIA

  • 926 Answers
  • Posted on Jun 18, 2009

SOURCE: 2000 Honda Odyssey no light shows only in D4

replace the bulb on dash its burn

Anonymous

  • 2 Answers
  • Posted on Jul 26, 2009

SOURCE: transmission would not shift from first then

I don't know if this will help but I 'll give you my experience .... I have a 90 accord ex 2.2 l ( love these hondas) and my s light kept flashing .... I bought a book , took it to honda of fife they said i needed a new computer 750 bucks yaeh right....... I did some tweakin under the hood and found a broken transmission solenoid sensor wire and fixed that and noticed my tranny fluid level was a quart over full, so i drained some out.... used an ohm reader and found one faulty temp sensor of 4 or 5 , changed that (the main one for the fans) anyhow I am almost certain all my troubles stemed from the computer getting the over full signal or the faulty tranny solenoid reading..... now everything is top on it .... but before the computer kept me locked out of half of my tranny, ...........

Anonymous

  • 1 Answer
  • Posted on Jan 18, 2010

SOURCE: 92 honda accord ex - No power on D4..

Describe what do you do if your D4 light is on a 92 honda accord ex and wont let you take off fast Problem

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

LG 50PC5D-UL plasma tv not getting a picture.

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://electronicshelponline.blogspot.com/
http://electro-medical.blogspot.com/
Blinking codes details of many popular brand TVs are given. Surf the site with patience.
0helpful
1answer

Hi , i have a problem with a plasma LG 42PX3RVA, the set turns green when you press the power button but no picture or sound , i measure the voltage on the boards and found thay it was correct acco

Bulb overheated and probably blew, they are made of mercury most times so don't touch them they should be in a housing, that could be it. If most times dust gets in there and the fan gets weighted down with dust if its up against the wall no air flow, so there ya go, try that. good luck
1helpful
1answer

My lg plasma tv when we turn it on blinks green 2 times then goes back to red

check for shorted components on YSus board and Y Driver boards (the boards on the left with the back off) This job is for a tech type person.
0helpful
1answer

Standby light changes from red to green

hi this fault could be down to capacitor in the power supply, they bulge or go leaky, you need to take the back off the tv, to have a look. try and find a tv tech in your area hope it helps

regards
shaun
0helpful
1answer

Panasonic plasma tv turns on but no picture or sound

Same issue with - Panasonic TH-50PX70A , power UP with red standby, then power ON by remote - only Gives GREEN led blinking 35-40 times, followed by solid green led with no no picture no sound.
>> Solution; unplug Plasma from AC 10-15min, then plug in & power on to Red standby led,, At this point - Power ON tv while holding down both -Volume Down and F (function Select) buttons (front panel door) at the same time turns picture ON,all ok.

7dfbfeb7-b9a8-4b46-ba57-237faf0ad8b2.jpeg
4helpful
3answers

Black screen

first try the address board or buffer board.if this
does not repair it,the panel is defective.
0helpful
1answer

LG 50PC5D Lightning serge

replace the mainboard, it is damaged
0helpful
3answers

No picture, no sound.

Hi i have a pilips 42" plasma tv (42PF5320/79) i can hear clicking the green light is on and the tv will go into stand by if i press the power button and the red light also comes on .I have turned it on and off and it works now nothing just the light on the front as if its working looking at the back through the slots two green lights come on then the tv clicks and they turn off,thanks
1helpful
4answers

Planar PDP42BK Plasma TV

It is the power supply. Replace the C97, C19, and C16 Capacitors with 2.2 uF ones.
Not finding what you are looking for?

62 views

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6687 Answers

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...