How do I fix my car when I hooked up to much power to it and now it won't turn over the dash lights will not turn on but everything else in the car works fine the AC Windows headlights turn signals but no ignition

SOURCE: Electrical problem

I just had the same issues. No headlights, interior lights, power door locks, radio controls on steering wheel, or dash lights. Pulled every fuse in cab and under hood, not a one was bad. I disconnected the battery terminals for a few minutes. When I reconnected them every thing was working.

SOURCE: 2004 Jeep Grand Cherokee - problem with power windows/locks

This seems to be the affects of a bad dinamo charging your battery . If you take a appart the dinamo you should fine a part called in mechanic terms "the bones" they look like 2 black magnets with a wire coming out of them . They are not expencive and you should not change your dinamo untill you try this first a car dinamo is very expencive .

SOURCE: Car will not start after installing CD player into a 1999 Saturn!

Check your Ignition 1 & ignition 3 fuses in the inside fuse block,also check the body fuse 10amp in the inside fuse block.Keyless entry should take back off once you found the blown fuse.hope this helps

SOURCE: 1999 ford crown vic dash light running light problem.

Check all the bulbs at tail end for parking and brakes, test grounds and harness for trailer. Check fuses. clean batery terminals, Re instal head light swich properly and make sure all wires conect.
Vitally

Testimonial: "thank you for quick response will try all of your suggestions will re post if no luck."

SOURCE: 1996 Ford Windstar tail lights and dash lights stopped working

No. All those lights are on the same fuse and are controlled by the headlamp switch.

Make sure that the fuses were all checked on the fuse panel inside the vehicle under the dash. That is where the fuse for those lights is.