Question about 1994 Chevrolet S-10

1 Answer

1994 Chevrolet S-10, won't start. The fuel pump tests fine. Have checked all the relays we can find. Starter will fire, but acts like it isn't getting gas.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 197 Answers

Have you checked the injectors (depending on modle) or the needle in the carb to make sure it's not sticking. If you have the carb model, pour about I/2 cup of gas into the air intake, assuming you have taken it off first, stand well back and turn over the engine. If it fires up, then dies, the carb needle is out, Take the top off the carb and you should see where the needle has been wearing against the carb, you can buy replacement needles for a few cents. if it's the inj model, it's a specialist job to clean the jets out, so you dont damage them, to only cost you more in the lng rn. be careful what ever you do. Regards Dave

Posted on Aug 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Have a 2000 GMC Yukon Denali. Won't fire.


Make sure that the belt isn't extremely tight and they the belt tensioner isn't liked up by pulling in the belt. It should move and spring right back. Make sure engine isn't locked up. And please explain what happen with the vehicle. The fact that you replace plugs and wires and fuel filter for a car that's not turning is throwing me off. So right now we are going all over the place. But definite look at belt and tensioner I've seen a few times that a bad tensioner will make the belt wrap around tighter inhibiting the engine from turning.

Jun 26, 2012 | GMC Yukon Denali Cars & Trucks

1 Answer

My 2000 chevy s10 pickup won't start it acts like it wants to but wont


scanned wont pick up failed fuel pump--or clogged fuel filter check and test wiring --relays--connections and fuses

Jul 16, 2017 | Cars & Trucks

1 Answer

1994 Chevrolet Lumina 3.1 will not start - after starting with ether runs fine.... 1994 Lumina 3.1 will not start - cranks but won't start. While cranking shoot ether into intake - starts...


Had friend put OBD diagnostics to it and error code indicated fuel pump ????? No code indicates replacing any part . Indicates testing ! pressure and flow testing , voltage drop testing the electrical circuit etc... There is a check valve in the fuel pump assembly that is suppose to keep pressure in the fuel lines an fuel rail . When the check valve goes bad allows fuel to drain back into the tank. Try turn the key on an off a few times to build up pressure . The PCM energizes the fuel pump relay for two seconds at key on .

Jun 13, 2017 | 1994 Chevrolet Lumina

1 Answer

Stop on stop sign engine died


If the engine won't fire up, but your starter turns over, you may want to check your timing unless you have a check engine light on. If the CEL light is on, have the codes scanned.

If the engine won't turn over with the starter or it clicks, have your battery tested at autozone or advanced auto parts. Replace the battery if it is bad. Else, have your starter tested.

If the engine still won't turn over and the battery and starter are tested fine, you may have a blown fuse, bad ignition switch, or a failed relay.

If the engine fires up but randomly dies and starts back up, you either have a failed sensor, failing fuel pump, clogged fuel filter, bad plugs or wires, or a failing ECU.

Sep 06, 2011 | 1996 Nissan Quest

1 Answer

Fuel pump not turning on. Won't fire but will turn over. swapped out relay, still not fire.


Try banging on the fuel tank, and then quickly try to start it, if it starts your fuel pump is almost dead and will need replaced soon.
If it doesn't start, test for power at the wiring connector on top of the fuel tank. This test requires 2 people, because the fuel pump is only powered for a few seconds when the engine isn't running. If you have power, then the problem is in the fuel pump (completely failed or bad wiring connection on the pump/inside the sending unit)

Aug 24, 2011 | GMC Jimmy Cars & Trucks

1 Answer

96 chevy k1500 5.7 runs good starts hard, turn it over and it wont start if i bump the starter a couple of times it will start then run good and will start no problem if it does not sit for a long period...


The problem on your vehicle is much more likely to be the oil pressure sending unit ore the fuel pump relay . The way the systems works is the fuel pump is supplyed by the fuse box fuse #9 but the cirrcuit splits and goes to the oil pressure sending unit in case the relay fails when your drivering the fuel pump will still have a power supply its stupid but its a safty thing that was mandated. If the fuel relay is NG the vehicle will still start but it takes the engine some time to build up enough oil pressure to trip the switch inside the sending unit to send volatge to the starter . Witch means slow starts long cranking times I would check the fuel filter first but realsticly if you don't know if the fuel pump has been replaced or you haven't done it your self this is vary likely the cause of the problem . If you have then try the oil pressure unit

Jul 23, 2011 | 1996 Chevrolet K1500

1 Answer

My 1999 masda 626 won't start. it turns over but acts like it isn't getting any fuel.


check relays/fuses first then the pump if you know how to test it
the pump is easy to test locate any fuel line unplug it tell a friend to make a quick one key turn if squirts fuel then pump is fine
but check the pump relay first to make sure and to begin with simplest
it seems you can tell it is the pump but you don`t know where to start

Jun 07, 2011 | 1999 Mazda 626

2 Answers

1994 chevy s10 blazer turns over, won't start


try replacing the fuel regulator,or is the oil cap on tight?the fuel regulator works on base vacumm

Sep 05, 2009 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
1994 Chevrolet S-10 Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...