Question about 2001 Mercury Sable

Open Question

My 2001 mercury sable auto headlights is not working and I now have to turn my headlights on manually, how do I fix this problem?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
warlock61
  • 659 Answers

SOURCE: Oxygen Sensors

ok Bank 1 is the rear bank and bank 2 is the front bank sensor 1 in each bank is the one closest to the manifold they have green connectors sensor 2 is the sensor after the cat converter and is a blue connector

Posted on Dec 02, 2008

Ad
  • 1 Answer

SOURCE: 2001 Merc. Sable headlight replacement

There are two 10 millimeter bolts that must be removed. Place these in your pocket or a convenient place so they will not be mispalced or lost. Also you need to pull upwards and remove an aluminun locking tab(coated in black plastic). After this is done carefully slide assembly foward. Press down on the wiring harness clip to remove it from the headlight bulb assembly, Turn the locking ring on the bulb to the right and remove so you can remove the bulb. Twist bulb out. When replacing new bulb do not touch the glass portion of the bulb. If you do so clean off with alcohol. Oil from your fingers left on the bulb will cause the bulb to overheat and fail prematurely. Replace bulb and secure with locking ring. You may also want to change the yellow parking/signal light bulbs at the same time. Clip wiring harness back on and slide headlightassembly back into place. Slide aluminum locking tab back into place. Now hand thread 10mm bolts back into place, Then tighten, do not over tighten. Now do the other side. First time might take you about 10 minutes per side. After that you could do it in a couple of minutes. Info on performing this maintenence can be foud in the owners guide or by downloading the guide from the following link http://www.motorcraftservice.com/pubs/content/~WO1SAB/~MUS~LEN/40/01sabog3e.pdf

Hope this info helped.

Posted on Jan 04, 2009

  • 1 Answer

SOURCE: 2003 Mercury Sable headlight bulb replacement

This problem is now resolved, thanks to a prior post by sableowner.

http://www.fixya.com/cars/t1479995-2001_merc_sable_headlight_replacement

The 2003 Sable has the same headlight assembly and removal/replacement instructions as the 2001 Sable. Once I had this information in hand, bulb replacement was easy.

Posted on Jan 13, 2009

  • 1 Answer

SOURCE: 2000 MERCURY SABLE

My 2000 Sable starts blowing hot air about every 6 months. I mean like an oven. All I do is disconnect the battery negative terminal for about 5 minutes. After I re-connect the problem is solved. This solves many problems on this car, it just needs a re-boot. It must be powered by Microsoft (ha ha). Good luck. ps my auto headlamps never did work right either. Dave.

Posted on Apr 21, 2009

greg_margo
  • 1959 Answers

SOURCE: mercury sable 2001 duratec engine DOHC I get check engine light and diagnostic code PO401". Any suggestions?

Barring any vacuum leaks, P0401 is indicative of a bad EGR valve. Hope this answers your question. Best of luck.
Greg

Posted on May 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Headlights, low beams work fine. when high beams are turned on, the left side goes out completely and there is no change to the right side.


Mercury Sable - YouTube

? 6:06
www.youtube.com/watch?v=Mlb1V5vNgFM
Jan 3, 2012 - Uploaded by 1A Auto Parts http://www.1aauto.com/1A/HeadLights/Mercury/Sable/1ALHP00223 ... Find out why. Close. How to Install Replace Headlight and Bulb Mercury Sable 00-05 ... How To Install Replace Fog Lightand Bulb 00-03 Mercury Sable

Oct 08, 2015 | 2005 Mercury Sable

1 Answer

2003 Mercury Sable when apply brakes hard theft light comes on


check the over load circuit breaker for the lights going out. Run fault codes to find the ABS/ Traction control sensor problem

Feb 16, 2014 | 2001 Mercury Sable

1 Answer

Mercury Sable auto headlights on off switch troubleshooting


More than liekly it isn't your switch. You have a ambient light sensor (sometimes called a photocell or amplifier) that detects how dark or light outside which in turn turns the lights on or off. this sensor is located under that "grille" just below the windshield. Sometimes water can stand in there and cause that sensor to go faulty. I say it's that in most cases because a switch, if it goes in most cases it just goes period. It is a fairly common problem also. Hope this helps....

Jul 14, 2013 | Cars & Trucks

1 Answer

How do you replace the headlights on a 2001 Mercury Sable?


2 bolts and 2 metal clips that pull up to releas the headlight.

Mar 03, 2010 | 2001 Mercury Sable

1 Answer

The headlights do not activate automatically, in the auto mode, at night or with minimal daylight. However the running lights will activate in the auto mode. A new dash light switch was installed without...


The light sensor to control the automatic headlamps is located on the dashboard. This sensor is suppose to activate running and headlamps. I would suspect the problem is a relay to operate the headlamps if the car uses a seperate relay in the automatic mode. I'm assuming the headlamps work in manual on/off. FYI... The auto mode does not control the fog lamps.

Nov 15, 2009 | 2001 Mercury Sable

1 Answer

2002 mercury sable auto sencor don't work?


were is the auto senor for the headlights in a 2002 mercury sable

Aug 23, 2009 | 2001 Mercury Sable

1 Answer

2003 Mercury Sable headlight bulb replacement


This problem is now resolved, thanks to a prior post by sableowner.

http://www.fixya.com/cars/t1479995-2001_merc_sable_headlight_replacement

The 2003 Sable has the same headlight assembly and removal/replacement instructions as the 2001 Sable. Once I had this information in hand, bulb replacement was easy.

Jan 10, 2009 | 2003 Mercury Sable

2 Answers

Instrument Cluster lights do not go on, emergency lights steady- Sable 2002


Has anyone figured this problem out? Our 2002 Sable just started this as well...instrument cluster lights out, turn/hazard lights on when the headlight switch is turned on. This has the auto on/off switch with fog lights. This is happening in the auto and manual on mode. Any solutions would be appreciated.<br />

Oct 23, 2008 | 2001 Mercury Sable

Not finding what you are looking for?
2001 Mercury Sable Logo

Related Topics:

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...