Question about 1997 Mazda MPV

Open Question

1997 Mazda MPV 3.0 cruise control is not working fuse ok Help?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
stuarttx
  • 15 Answers

SOURCE: program remote control for mazda mpv 2002

Courtesy of: forums.mazdaworld.org

Try this, it works on several 2002 models:


Step 1: Open drivers door and leave open.

Step 2: Lock and unlock the drivers door using the power door lock switch on the door.

Step 3: Insert key into the ignition.

Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.

Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).

Step 6: ECU should respond by locking and unlocking the doors.

Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.

Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.

Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done

Posted on Feb 21, 2009

Ad
  • 1 Answer

SOURCE: 1997 Mazda MPV, 3-Ltr. V6, destroys Timing Belt

i need help install a timebelt in a mazda mpv? please help me out

Posted on Aug 05, 2009

Hrnsly
  • 154 Answers

SOURCE: the cruise control is not working 2002 Mazda Tribute

you have a bad cruise cable, this is a very common problem with the tribute. just go to your local dealer and have them replace it for you, it only takes about 30 minutes to do

Posted on Aug 13, 2009

Hrnsly
  • 154 Answers

SOURCE: 2003 Mazda tribute cruise control stopped working

the problem is more likely the cruise cable its self. if you pull the engine cover you will probably fine the cable has fallen off at the throttle body. the only way to fix this problem is to go to the dealer and buy a new cable.

Posted on Aug 18, 2009

  • 740 Answers

SOURCE: no heat inside van

THERE IS A DOOR UNDER THE DASH THAT MOVES FROM COOL OR AC AIR TO HEAT CHECK AND MAKE SURE ITS MOVING WHEN CHANGING SETTINGS

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get to fuse box in 1997 mazda mpv


There is an under hood and under dash fuse box on your 1997 MPV. What are you trying to fix?

Nov 11, 2015 | Mazda Cars & Trucks

1 Answer

1997 mazda 626 cruise control not working


Check the 20A STOP FUSE and 10A METER FUSE in the joint box but also there may be no speed sensor input that signals the cruise control to engage.

Sep 09, 2014 | 1997 Mazda 626

1 Answer

Is their a fuse for the cruise control and if their is where is it ? when i turn it on nothing not even a light on the dash


There is fuse but it is a shared fuse called the "meter" fuse. If that was the problem then your turn/hazard lights and instrument cluster would not be working either. Could have a problem with the main switch or clockspring which allows signals to go thru moving contacts of steering wheel. Check to make sure the Cruise control actuator electrical connector up under the hood has not come loose or been left disconnected fromo prior repair.

May 24, 2011 | 2004 Mazda MPV

2 Answers

Engine cuts out when steering wheel tilt is adjusted. Also, cruise control not working.


For the cruise control, check the fuses under the steering wheel. As for the engine cutting out, don't adjust the steering wheel while driving.

Apr 16, 2011 | 1994 Mazda MPV

2 Answers

Need to know location of fuel pump relay on a Mazda mpv 3.0l v6 1997 model


The fuel pump relay is located below the right side of the dash to the left of the engine control module. There is also a 15amp fuse
for the fuel pump. In the fuse block under the left side of the dash
fuse #19. Hope this helps.

Mar 18, 2010 | 1997 Mazda MPV

1 Answer

1997 Mazda 3.0 MPv Idle problem


check MAF sensor or for vacuum leaks

Oct 20, 2009 | 1997 Mazda MPV

2 Answers

1997 Mazda MPV, 3-Ltr. V6, destroys Timing Belt


i need help install a timebelt in a mazda mpv? please help me out

Jul 14, 2009 | Mazda MPV Cars & Trucks

1 Answer

Mazda 200 MPV radio is not working


did you ever find the problem, I had the same thing happen.

Dennis

Jul 07, 2009 | 2005 Mazda MPV

1 Answer

I do not know where the cruise control is located Mazda Miata


Main Switch Is Located LEFT of Steering Wheel Down Low and there are 3 Switches and Cruise switch is the One on FAR LEFT

Mar 29, 2009 | 1997 Mazda MX-5 Miata

3 Answers

Cruise Control Not Working, Fuse OK, where do I go next?


my 1997 honda accord cruise control fuse blow and the car start up but will not go in gear. I change the cruise control fuse the car goes in gear then the fuse blow again. WHAT IS THE MY CAR PROBLEM.

Oct 01, 2008 | 1997 Honda Accord

Not finding what you are looking for?
1997 Mazda MPV Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...