Question about 1992 Lexus Es 300

2 Answers

The car will start but you have to keep your foot on the accelerator to keep it on if you take your foot off it turns off

Posted by on

  • ela_vaka Aug 02, 2009

    my 1992 lexus es300 starts but wont stay on you have to keep your foot on the gas pedal in order to keep it on it doesnt spudder or back fire

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Either a coil pack is bad and spark is not hitting every cylinder, Or you have a vacuum leak. Also possibly there is a bad sensor but check engine light should be on.

Posted on Aug 02, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,314 Answers

It could be any number of things; without details it will be pretty hard to troubleshoot. Could be idle is just set too low but again hard to tell without more details.

Posted on Aug 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why doesn't it continue running after start up?


Carburetor idle circuit is not working - carb needs to be cleaned and reset to restore normal operation.

Feb 14, 2016 | 1986 Nissan Pickup 4WD 1986

1 Answer

Car will not accelerate when gas pushed


Clutch plate and pressure plate seem to be too weak to pull the car. To test the clutch plate, park the car on flat surface. Pull the hand brake up, start the car, depress the foot brake pedal, depress the clutch pedal, put the car in 1st gear, press the gas pedal and leave the clutch pedal at once, while keeping the brake pedal depressed.
Follow one of the two following statements:
1. Engine does not shut down and remain start. (Clutch plate, pressure plate and clutch bearing defective - Replace all as a set)
2. Engine shuts down. (Clutch system is OK and does not require any repair).

May 22, 2013 | Honda Civic Cars & Trucks

1 Answer

Have a 97 corolla that takes long to start and after starting u need to keep your foot on the gas pedal because it does not idle properly and cuts off. If u keep your foot on the gas pedal for about 5...


Possible Intake Gasket Leak, Have someone turn engine over while you spray Carb cleaner or propane on intake where it bolts to cylinder head. Good luck

Feb 12, 2018 | 1995 Toyota Corolla

1 Answer

Starts but you have to keep your foot on accelerator


Powertrain Control Module
There is an idle speed motor on the side of the throttle body, I would thouroughly clean throttle body.

Jan 15, 2013 | 2003 Dodge Dakota Club Cab

1 Answer

Driving car just shutoff want start again


Check to see if it is flooded, When you attempt to start the car put your foot on the accelerator and put it to the floor, keep it to the floor whilst trying to start the car yet dont pump the accelerator just keep it flat to the floor.

If it turns over the starter motor is fine,

Fuel Filter and pump is fine,

You got a spark so the electrics will be fine,

Just need to limit the problem down to whats happening under the head.

Oct 20, 2012 | 1999 Saturn SL

1 Answer

Not accelerating when start the car...


if you went the route of changing the plugs, try the spark plug wires, and the distibutor cap

Jun 17, 2009 | 2000 Chevrolet Prizm

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

918 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...