Question about 1998 Land Rover Discovery

1 Answer

R reg discovery taking a long time to start. i have changed the glow plugs , the battery is quite new .fuel filter is new. any ideas?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

Check the fuel lift pump does it pump fuel (remove outlet pipe and operate pump lever check to see if inlet pipe has not cracked and allowing air to enter the fuel system

Posted on Sep 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vw sharan w reg turns over and sometimes fires but then dies, now wont start at all.


Just some info could be filter or fuel pump. copy and paste to google search. diesel which is takes some time to crank.
https://www.youtube.com/watch?v=yRMTEAKsScE

Aug 04, 2017 | Volkswagen Sharan Cars & Trucks

1 Answer

I HAVE A 2006 FORD F-450 AND IT WON'T START I HAVE


Take off the Fuel filter and see if it is dry. If it is dry you know its a fuel line bleeding down or a fuel pump. Prime the new filter with fuel and see if the engine will hit.

Since you replaced the Glow plugs did you test the circuit? You should be able to test each plug wire when the engine is in startup. You can take out a Glow plug and ground it with a battery jumper cable while it gets power from its wire off the controller. The plug should heat up. Or you can just test the wire with a meter.

There are crank position sensors and cam sensors I believe on this model. Check with Autozone after you do the other tests.

The last case would be the worst, jumped time or problems with timing gears. Like to know results and Good Luck.

Mar 29, 2010 | Ford F-450 Cars & Trucks

2 Answers

How easy is it to change glow plugs in a 1995 (N reg) discovery?


should be handy enough just screw out put new one in
if your machine hard to start when heating in the morning ,wait twenty seconds after light goes out then crank it
heater relay still working when heat indicator light goes out

Feb 25, 2010 | 1995 Land Rover Discovery

1 Answer

Won't Start & No glow Plug Light on Dash


I am with a similar problem...

After putting on a new sump i found that the starter motor would work cranking the engine but no power is going to the glow plugs. The light on the dash does not appear either.

The relay for the coils does click but that is the end of it. I have a suspission it is the imobiliser but after taking the battery on and off several times to reset... still nothing.

There is fuel, good battery (fully charged), fuel lines are clean pressurised...

Any ideas???

Feb 11, 2009 | 1991 Peugeot 405

2 Answers

Land rover discovery 1996 very sluggish when trying to start


sounds like you gotta lazy starter motor,put a current clamp on it and see what the current(amps)are a high load and you got a dodgy starter.a good mechanic would have tested that...

Oct 19, 2008 | 1996 Land Rover Discovery

1 Answer

Landrover discovery l reg 1994 .when i start the car it starts fine , when i try to turn it off the engine still runs and the battery and glow plug lights come on. i have to stall the car to turn it off...


its the fuel pump cut off switch... just change the switch which is located in the fuel pump.it look like a big screw with 2 or 3 wire coming out of it.

happy trying.

Oct 18, 2008 | Land Rover Discovery Cars & Trucks

4 Answers

1996 discovery starting problem


Hi.

Make sure there is voltage going to the fuel solenoid on the pump, i did the same with my landrover and it just would not start or would start and just cut out, turned out to be the wire going to the fuel solenoid was not working, just re-wired from a wire behind the dash board that supplied enough voltage, that when the landrover had started the wire then supplying voltage.

Just check by putting a multimeter on the fuel solenoid wire and turn the engine over if the voltage drops to below 12v then it`s most likely the same problem i had.

Jun 13, 2008 | 1996 Land Rover Discovery

Not finding what you are looking for?
1998 Land Rover Discovery Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...