Question about 1990 Ford Taurus

1 Answer

1990 Ford Taurus SW 3.0L Power Problem

1990 ford Taurus Station Wagon 3.0LOk I have another question! We disconnected the battery when we replaced the ignition solenoid we installed the new ignition solenoid and noticed a fusible link that runs from the solenoid to the ignition switch was melted! If we replace that fusible link I get power in my ignition again I have absolutely no power anywhere in my car. I know it is not the fuses cause I checked them and I have a bran new battery. Please Help

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 47 Answers

CHECK GROUND WIRE FROM BATTERY TO BODY AND BODY TO ENGINE

Posted on Aug 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What fuses will get my radio working in my 1994 ford taurus station wagon


Are you sure it is fuse or Radio security code that goes out if the battery is disconnected?

Mar 12, 2015 | 1994 Ford Taurus

1 Answer

1995 Ford Taurus Station wagon will started sputtered ,jerked and died. changed sparkplugs replaced heating coil replace egr valve no luck


ignition system seems to be ok, check fuel system like fuel pump filter and injectors or carb, make sure fuel pump is working properly.

Dec 12, 2013 | 1995 Ford Taurus

1 Answer

My 1990 ford Taurus station wagon just died on my like it was out of gas and I reset my fuel pump but that didn't help


Are you getting fuel pressure to the injector rail, and how did you reset your pump ??

Jan 09, 2013 | Cars & Trucks

1 Answer

1999 ford tarus se comfort station wagon it will not start or turn over battery seems to be okay


Have to test or replace battery

Then have to test starter solenoid & or starter

Could be ignition switch or other items in starting system

Nov 23, 2012 | 1999 Ford Taurus

1 Answer

I have a 1994 ford taurus station wagon, the battery won't stay charged, the confusing thing is that the inside panel and door light works


you have a faulty alternator by the sounds of it, try this simple test, : test the voltage of the battery with the vehicle off with a simple multimeter, it should read just over 12v then test it with the car running, it should read around 14-14.5 volts if it still only reads 12v then your alternator needs replacing.

Sep 13, 2012 | 1994 Ford Taurus

1 Answer

I have a 2002 ford taurus station wagon and the battery is not charging. We changed the battery twice and still not charging.


You need to have your alternator checked.... A good sign is if you start your car and take the pos. battery cable loose and the car dies chances are your alternator is bad...

Oct 30, 2011 | 2002 Ford Taurus

1 Answer

I need a diagram of how the plug wires are put on 1999 ford taurus station wagon


1999 Ford Taurus 3.0 liter V-6 VIN "2"

zjlimited_234.gif


1999 Ford Taurus 3.0 liter V-6 DOHC VIN "S"
and
1999 Ford Taurus 3.0 liter V-6 VIN "U"

zjlimited_235.gif


Hope helps (remember to rate and comment this answer).

Mar 07, 2011 | Ford Taurus Cars & Trucks

1 Answer

Passenger side mirror replacement procedures


If its a power mirror there is more thing you will have to remove to get to the wires but if not there is a screw on the corner piece on the inside of the door. just pull the screw out and the bolts (3) that hold the mirror on are behind it. If it power then you will have to remove the door panel to access the wiring to disconnect it

Jun 21, 2009 | Ford Taurus Cars & Trucks

Not finding what you are looking for?
1990 Ford Taurus Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...