Question about 1997 Toyota Celica

1 Answer

Can you tell me where the tire jack is located in a 1997 Toyota Celica?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Check under any carpet in your trunk, or inside the sides of your trunk. If you still can't find it, then I dont think you have one.
Best of luck...

Posted on Aug 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi there. i have a toyota celica coupe 1800. 16valve gen 6. 1997 model. is there anyone out there who can tell me were i can find were to locate the fog relay on the vehicle.


You will found it on your driver side kick panel all the way up hi, it is hard to reach but is there above fuse box side.

Apr 26, 2014 | 1997 Toyota Celica

2 Answers

My 1990 toyota celica has a bad vibration in the Problem with the Toyota Celica 1990 Celica my 1990 toyota celica has a bad vibration in the passenger side front i have replaced tie rod ends, ball joints,...


Hi,
Have you ever replaced the shocks / struts? Are you sure your tire does'nt have a bump spot or out of round? I usually will swap the tires front to back to see if the vibration or bumping moves, good way to tell if the tire is bad. I've gotten some pretty poor tires before, some do have factory flaws that will cause that. Shocks will cause that also. Sway bar pins / joints that are worn can cause that also.
Mike

Jul 30, 2011 | 1990 Toyota Celica

2 Answers

Where does a oxygen sensor go on a toyota celica 2000 ?


  • Locate the upstream and downstream oxygen sensors under the vehicle near the front axle. The upstream and downstream sensors resemble spark plugs with several wires connected to them. Remove the sensors by turning them clockwise with a 22-millimeter wrench.Locate the wiring harness inside the vehicle under the center console on the front passenger side. Disconnect the electrical connectors for the oxygen sensors. Feed the wires down through the vehicle and pull them out under the car.Feed the wiring assemblies on the new sensors up through the floor of the vehicle. Reconnect the wires in the wiring harness. Screw in the new oxygen sensors with your fingers. Once they are in place, tighten them with a 22-millimeter wrench.Remove the jack stands and lower the Celica to the ground. Remove the tire blocks. There should be a sensor before the CAT converter, and one RIGHT after it.


  • May 17, 2011 | 2000 Toyota Celica

    1 Answer

    Where is the location of rear window fuses on 1997 toyota gt


    LOOK UNDER HOOD AT FUSE RELAY BOX.LOOK ON FUSE COVER FOR FUSE LOCATION.

    Nov 12, 2010 | 1997 Toyota Celica

    1 Answer

    How to remove the STARTER FOR 2000 TOYOTA CELICA GTS


    From E-How because I didn't want to type all the steps :-)
    Instructions
      • 1 Disconnect the negative battery terminal and place the wheel chocks behind the rear tires of the car.
      • 2 Jack the car up using the automobile jack and place a jack stand under the car near the jacking point. Raise the jack stand up to the frame of the car.
      • Sponsored Links
      • 3 Crawl under the car and tag the wires on the starter according to their location using the masking tape and the marker. Disconnect the wires using a wrench to remove the nuts. Unplug the wiring harness from the solenoid.
      • 4 Remove the bolts from the starter using a socket and ratchet. Take care when removing the last bolt that the starter does not simply fall out and hit you.
      • 5 Put the new starter in place and bolt it in using the socket and ratchet. Reconnect the wires according to the labels you made and tighten the nuts with a wrench. Plug the wire harness back into the solenoid.
      • 6 Remove the jack stand and lower the car back to the ground.
      • 7 Reconnect the negative battery terminal and start the car to test the installation.
    Read more : http://www.ehow.com/how_7247287_replace-toyota-celica-starter.html

    Aug 30, 2010 | 2000 Toyota Celica

    1 Answer

    Water is backing up in the trunk of my 95 celica converable


    there are ussually rubber plugs in the bottom,if not use shop vac to remove water and fix leak check antenna if its metal and at the rear panel,other areas to check are the rear tail light gaskets.also look at tail mounting holes.

    May 18, 2010 | 1998 Toyota Celica

    1 Answer

    Rear tire is froze how do you free it


    are you removing the tire. is it rusted on..after loosening the lug nutsgive it a couple good wacks with a mallet. Make sure the jack is stable and a good kick will break free the rust bond between your rim and hub

    Apr 20, 2010 | 2000 Toyota Celica

    1 Answer

    What is the recommended tire pressure for my 1994 Toyota Celica GT


    it depends on the tires, look on the side of the tires and it will tell you the psi

    Dec 19, 2009 | 1994 Toyota Celica

    1 Answer

    98 Celica overheating problem


    c7d7b55.jpg Cooling Thermostat.
    Look along the radiator hose where it enters the engine. This controls the water temperature.


    toyotacelicathermalfanswitch.jpgToyota Celica Thermal Fan Switch The Toyota Celica thermal radiator fan switch is usually located in the radiator or the engine block and has 2 or 3 wires coming from the unit. The 3 wire switch has a dual sensor for dual speed radiator fans. The Toyota Celica thermo fan switches come in the factory temperature settings and also come in cooler thermostatic settings so the fan will come on at a lower coolant temp.

    The Toyota Celica cooling system is made of aluminum components and requires a Phosphate free coolant. DO NOT PUT an over the counter antifreeze in your Toyota Celica, as it will ruin the radiator and water pump.

    Feb 19, 2009 | 1998 Toyota Celica

    1 Answer

    Replacing a rear wheel bearing Hub on a 2001 celica 190?


    I had this same problem myself. The hub is a sealed unit and must be purchased as a whole assembly to the tune of around $400 from Toyota. Long story short I never replaced my hub. The problem turned out to be tires that were worn out. I figured that out when i rotated the tires and the sound moved to the front of the car... Go figure. Replaced the tires and all the noise went away.

    Jul 08, 2008 | 2001 Toyota Celica

    Not finding what you are looking for?
    1997 Toyota Celica Logo

    Related Topics:

    98 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Toyota Experts

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8195 Answers

    Are you a Toyota Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...