Question about 2006 Nissan Maxima

Open Question

2004 Nissan Maxima Hazard lights do not work

Hazard lights do not work- Looked under hood to see if relay & My under hood diagram is so blurry can not read it.ANYONE HAVE A under hood diagram for 2004 Nissan Maxima 3.5SE

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pal03246
  • 705 Answers

SOURCE: 2004 nissan maxima

Take a look at your gausett brackets, by the front exhaust tube. 2 sheet metal lookig brackets, each held up by 2 screws each. Those gausetts brake and cause a rattle, Common problem on a MAxima your year. Nissan has a TSB for replacement of these brackets.

Posted on Jul 26, 2008

SOURCE: WHERE IS THE CAM POSITION SENSOR LOCATED ON A 2004 NISSAN MAXIMA

WHEN YOU STAND ON THE FRONT OF THE CAR YOU ONE IS RIGHT BELOW OF THE INTAKE WHICH IS BANK 2 OR THE ONE CLOSE TO FIREWALL , BANK 1 ONE IS ON SAME SIDE NEXT TO THE RADIATOR BUT THEY BOTH ON THE CAM RIGHT SIDE OF THE ENGINE, THE EASIEST WAY TO IDENTIFY THEM IS THAT THEIR CONNECTOR IS GREEN, ONCE YOU LOCATE THEM THE CLIP NEEDS TO BE PUSHED DOWN TOWARD THE SENSOR FOR THE CONNECTOR TO BE RELEASED, ONCE YOU REMOVE THE CONNECTOR THERE WILL BE ONLY A 10MM SCREW HOLDING THE SENSOR PULL IT OUT , THE SAME SETTING THE NEW ONE PUSH IT ALL THE WAY IN , THIGHT THE 10MM SCREW, CONNECT IT BACK AND YOU'RE DONE,BUT FOR THE ONE ON THE BACK SOMETIMES MIGHT BE NECESARY FOR YOU TO TAKE THE INTAKE OFF....HOPEFULLY IS NOT YOUR CASE....



Good luck!!! and if you need the crank for hard starting on hot/warm, it is located on the botton middle section on the transmission is the only cable that goes down to a small piece of metal and it is held by a 10mm screw only to protect the sensor, you will se the sensor once you remove that small about 6-8 inches piece of metal. Then you'll be able to unescrew the 10mm screw that holds the crank position sensor. when you pull it off you'll be able to see the fly wheel inside the transmission...



you all enjoy your rides out htere!!!

Posted on Jul 01, 2009

  • 3 Answers

SOURCE: Ignition switch won't turn over starter

put key in trunk and pop it try this it may work

Posted on Jul 07, 2009

SOURCE: I NEED A DIAGRAM OF THE FUSEBOX AND RELAY BOXES

On the cover of the fuse box indictes what each fuse/relay controls

Posted on Sep 18, 2009

  • 1 Answer

SOURCE: 2004 Nissan maxima fuse box diagram

2004 Nissan Maxima - Trunk will not open, tried using the key fob - nothing, tried the lever on drivers door, nothing - still won't open.

Posted on Mar 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ecu fuse on a 98 nissan maxima


Relay is under the hood. Dash light could of burnt out. Check out Maxima.org

Sep 17, 2014 | 1998 Nissan Maxima

1 Answer

2004 Maxima, front, rear running lights, dash dimmer don't work. Lamps and fuses are good. Possible cause(s)?


All lighting fuses and relays are in a plastic box under the hood close to the battery on top of the inner fender well. Do not mess with the computer, it has nothing to do with the lights. check every fuse in the box under the hood.

May 23, 2017 | 2004 Nissan Maxima

1 Answer

I shorted my light for my plate in the back and now the radio ,shifter and lights in the back r not working i checked fuses they r all good,now the check engine light goes on....any clues what the...


You would have to have the code read for the check engine light and that may just be a result of the shorted rear light but you need to have it checked, clear the codes and then see if it pops back up. When that light shorted it it may have shorted the relay in the power distribution box under the hood.

Sep 10, 2011 | 2004 Nissan Maxima

1 Answer

ABS, dashboard out, air condition wont come on, turn signals and hazard light wont come on in 2005 nissan maxima? replaced a few blown fuses inside the car under steering wheel any suggestions


check if the relays under the dashboard are working. also ensure that the battery is well charged. check if power cables from the battery are not cut. also ensure that the replaced fuses are not blown.

Jul 01, 2011 | 2005 Nissan Maxima

1 Answer

I have a 1996 nissan maxima, lights, radio, and everything else works but the car won't crank. We replaced the starter ourselves but it still can't start. What else could be the problem?


Try swapping the starter relay with the wiper relay(they are in a fuse box, located under the hood). If it starts, your starter relay is bad.

Jan 06, 2011 | 1996 Nissan Maxima

2 Answers

My fog light don't work


fog lights not working 2005 maxima. is there a fuse for the fog lights?

Apr 22, 2010 | 2004 Nissan Maxima

1 Answer

2004 Nissan maxima fuse box diagrams both under hood and in door


2004 Nissan Maxima - Trunk will not open, tried using the key fob - nothing, tried the lever on drivers door, nothing - still won't open.

Feb 13, 2010 | 2004 Nissan Maxima

Not finding what you are looking for?
2006 Nissan Maxima Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...