Question about 1993 Chevrolet C1500

1 Answer

1993 silverado tranny

The transmissions quiet pulling in over drive

Posted by on

  • Curt Downs May 11, 2010

    Sounds good to me. Your question is?

  • Ned C Cook
    Ned C Cook May 11, 2010

    This has got to be a good thing. What? you want it to make noise?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 467 Answers

Check the transmission fluid make sure its at its proper mark, not have a burnt smell

Posted on Aug 05, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 1993 Chevy WT1500 pickup with a leaking transmission.


did you use lock tight on the torque converter bolts when installing them? it may be coming loose and ruining the seals. It doesn't take much. You may have some kind of buildup on your output shaft or a bur of some type that is cutting the seal. Check the outside hub of the torque conv. for roughness or spurs. The seals should work if everything is done right.

Feb 01, 2013 | Chevrolet Cars & Trucks

1 Answer

1993 Chevy Silverado will not shift in to 2nd 3rd or Overdrive.


Are you sure its stuck in first gear, Its probably in second.. It sounds like a stuck or open shift solenoid in the tranny (4L60E hydra-matic). Depending on the year and type of tranny this was a default setting to either only second or only third gear, should some electrical or transmission hydraulic fault occur. Another common problem for that year is a faulty ignition switch at the key cylinder. It will fail and not send power to the tranny (thus not powering up the shift solenoids). The default (or limp home mode) is when both solenoids are commanded off. They will be both commanded off in second gear (even when the tranny is operating normally).

Jan 30, 2011 | 1999 Chevrolet Silverado 1500

2 Answers

I have a 1993 saturn manual transmission and when


Time to find a much lower mileage used tranny and have it put in. Replace the clutch components with new stuff while you are at it.Note that the transmissions 91-99 will most likely swap but you must know whether you have an SL1 or SL2 and the donor car must be the same..

Jul 14, 2010 | 1993 Saturn SL2

1 Answer

Install a radiator on a 1993 Chevrolet Caprice without oil cooler


you install radiator but did not install transmission cooler? Im not quiet understand the your questions? correct me if im wrong, The caprice has engine cooling systems which is the radiator and also a transmission cooler which cool the transmission. make sure you also hook up the transmission cooler, very important which help cool your tranny so it wont over heat.

Nov 06, 2009 | 1993 Chevrolet Caprice

1 Answer

2001 silverado. Auto transmission shifts very hard from 1st to 2nd after the transmission is warmed up. When just driving around town it seems to work fine but after driving for a distance (warming up the...


whens the last time the tranny was serviced as far as filter and fluid the tranny may not be getting enough line pressure if the filter is dirty, or low on fluid, cuasing the slippage

Sep 25, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

Need Directions to Replace clutch in a1993 5spd.toyota 4runnerV6


start off bt taking off your shifter, then disconnect the wires,cables, and the 4x4 linkage, the drop out both drive shafts, support the tranny and transfer case then remove the tranny mount. take out the bolts on the bell housing that go into the motor the pull out the slave cylinder,and the last thing to remove is the cross member that holds up your tranny. after that slide the tranny back about 6 inches tor until it's free from the block and lower it down. after you get it on the ground pull of out clutch fork that is in the bell housing of your tranny, pull the bearing off the shaft that is in the bell housing as well. and last but not least take off the clutch plate ans the clutch disk that is on the fly wheel on your block. and i cant stress this enough be careful when you pull the tranny out and make sure it will not fall on you. so please do it carefully. And take your time.

Mar 26, 2009 | 1993 Toyota 4Runner

2 Answers

Mercedes benz wont go into reverse


300e tranny reverese uses clutch disk for B3 and therefore no external fix. You will need to pull the tranny out and might as well rebuild the whole thing.

Feb 25, 2009 | 1993 Ford Taurus

1 Answer

Speedometer runs erratic and transmissions drops to second gear.


The ECM or TCM may be the culprit, its also possible that a ground wire is no longer grounded or partially grounded giving you the erratic speedometer.

Dec 08, 2008 | 1993 Chevrolet K1500

Not finding what you are looking for?
1993 Chevrolet C1500 Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...