Backrest is coming no quite all up, stops a step before.
SOURCE: drivers side seat not working properly
hi this sounds like the coiled spring that is enclosed behind the cover where the recline lever is it has either broken or the pin it locates on has snapped or spring has for some reason slipped its fastening ? try removing cover and investigate the spring and its locator points
SOURCE: Driver side seat back is loose
Sounds like your latch is broken. You can replace the latch, it is spring loaded .Once you remove the trim around the latch and pull the seat cover up you can gain access to the bolts. You will need a torx bit ,I believe a t40 not sure. 13mm and 15mm socket.
SOURCE: Ford drivers side heated seat doesn't work any ideas?
Most likely one of the heater elements in either the seat cushion or seat back is open.It leaves the module and goes to the seat back on the YE/LB wire thru the seat back and leaves there on the GY/LB wire and goes to the seat cushion and leaves there on the VT/LB. An open in either one of these will cause it not to work.Usally its the seat cushion one that goes bad.
You can test them with an ohm meter and you can get the heated element seperate. Just have to remove the cover to replace it.
SOURCE: releasing the backrest of the 2nd row of seats
i have a 2003 tahoe and you have to pull the bottom up to a certain point and then the back of the seat will unlock and fold down. it took me forever to finally figure that out. good luck.
SOURCE: drivers side power seat will not move forward and back
first thing to do is to remove that switch and test it with a multimeter with continuity check to see if the switch is working properly
basically you are checking to see if switch is completing circuit
333 views
Usually answered in minutes!
×