no voltage going to new fuel pump - 1999 S-10 4.3L 4WD AUTO-Truck would not start-couldn't hear the fuel pump kick on-sprayed ether in c arb started then died.Replaced fuel pump still won't kick on.Ran a hot wire to pump-it works.Replaced fuses and relay.Is there a fuel shut off switch or am I looking at a wiring problem?Maybe Oil pressure switch but I couldn'find it.HELP!!!
-
The GRAY wire i believe going to the fuel pump is the hot wire it should come on for 2 seconds with just the key in the on position this is were you should check voltage for 2 seconds then it will go away until you crank the truck.Your oil sending unit is behind your distributor that could be the cause .
You are looking at a wiring problem. Put a fuse in your hot wire and fasten it up and leave it there, unless you want to take the harness apart and replace the factory wire.
When I put my key in the ignition it will not turn- it is stuck "locked" and it is not...
(More)
When I put my key in the ignition it will not turn- it is stuck "locked" and it is not that cold out for that to be a factor - help please