To get the help you need service and repair manual which you can get from the given link http://toolsnyou.com/
SOURCE: Hood Won't Open, and Lever Broke
Hi viper852004 , the only way you can do this is to remove the front grills and then you will be able to see the 2 sprung bonnet pegs, you will need to loosen the adjusting nut where it screws into the hood and unscrew it until it becomes unattatched from the hood, do this for both pegs and then you should be able to release the hood to fix the problem. the pegs will need to be reinstalled before driving the car as the hood will not close, hope this is of some help, regards mark.
SOURCE: can't open hood
if you can still get to the little steel cable, a extremely tight pair of vise grips and a moderate amount of force will do the trick.
SOURCE: 1994 Lexus LS400 Broken Hood Cable - Hoe could I replace?
you have to route cable along the fender side under the hood like on battery side. you have to run it where it wont get in contact with drive belt.your cable has a ball of metal at the end of it.your hood latch should have a clip where you put your cable in it.you should not have to remove nothing.just drop cable in place.
SOURCE: Broken hood latch on a 03 Volks Wagon Passat
use a long flat tip screw driver and a small hammer. have someone pull up on the hood after you pop it from the inside, then while they are holding the hood up use the screw driver and shove the hook that is above the latch bar. when you hit it you will be hitting it to the right
SOURCE: the hood latch cable broke under the hood how can
Saturn Vue hood release can be opened (if the cable is not broken) by disconnecting the cable from the back of the release lever, grabbing the ball on the end of the cable with some large pliers ("channel locks") and pulling hard. A metal "wire keeper" bracket clamped to the cable end under the hood to serve as a spacer and the release lever works.
The purpose of this bulletin is to provide a procedure for opening the hood on the Saturn VUE and ION vehicles should the hood latch release cable mechanism become inoperative.
VUE Hood Opening Procedure
Modify the Saturn radio antenna by bending the antenna mast 1 in. (2.54 cm) above the antenna base to a 25 degree angle
Open hood of similar vehicle to locate hood latch release cable to hood latch attachment point.
Using modified antenna, note approximate location that antenna will have to enter in between fascia and hood to access the hood latch cable attachment point. This should be toward the left edge of the Saturn emblem. Also note position of the modified antenna base. It should be angled downward.
Note: Use protective tape on the hood and fascia where the antenna will be inserted to protect the surfaces from scratches
On vehicle with inoperative latch, insert antenna between hood and fascia and depress the hood latch cable until the hood is opened.
Good luck and thank you for using fixya
342 views
Usually answered in minutes!
×