Question about 2004 Dodge Neon

1 Answer

2004 Dodge sx 2.0 runs great but check engine light is on.?

I have a 2004 Dodge sx 2.0 with approx 100,000km on it. Everything runs great on it no probs except i have a check engine light that comes on just as i turn the key (car not started at this point).Even though i may be a woman i do know my way around an engine somewhat lol.gas cap is on properly (first think i checked lol it happen before lol ) anyone have any ideas. I tried the turn key 3x thing but no numbers came up. So anyone have any ideas what could be the problem.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

I take it the light stays on? You might want to check your air filter, might be stuffed. You can reset the Check engine light by disconnecting the battery while the ignition is in the 'on' position, either negative or positive( I generally go with the positive, feel better about it for some reason) leave disconnected for about a minute, during this time I turn the ignition to 'off'. Reconnect the battery, if the light comes back on, you might want to get it scanned with an OBD and see what error codes it gives you, could be an O2 sensor or anything.

Posted on Aug 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2004 Dodge Dakota. Runs great until it accelerates to about 4k rpms and then the motor spits an sputters. Anyone ever have this problem or know what might cause this? Would appreciate any advice!


Need more information. Is there a check engine light on? First thing I would check is the coil but you should have a check engine light on if that's the problem. Get the codes and it will help you alot on fixing your problem.

Sep 29, 2013 | 2004 Dodge Dakota

1 Answer

2004 Dodge sx 2.0 . Wheres the fuel filter ?


So you think its the fuel filter at fault? Is the engine light ON? and what are the trouble codes?

Jun 22, 2012 | Cars & Trucks

1 Answer

My 2004 v6 3.5 litre rodeo has been regularly serviced and maintained and now has 140000 kms on the clock but it has now developed a ticking sound which i thought would be the tappets and or valves but all...


look for obvious signs that the holden dealer did take off rocker covers and check/replaced shims for tappet adjustment you should have shims booked out on receipt if any were done. Alot of them dont do it because its very time consuming and a pain in the **** to do this job. This should have been done at 100,000km service. If the tapping noise is there constantly at idle and approx 1200-1500rpm and gets louder if you stab the throttle at this engine speed its a tappet or other engine noise(big end bearing), if the noise comes in and out at a constant engine speed idle and 1200-1500rpm your valve guides are worn. both of these were common for this engine.

Jan 07, 2011 | 2004 Isuzu Rodeo

1 Answer

2003 dodge cummins had to start runs great when started. i changed the lift pump/cp3 pump/2 injectors and cam sensor still have starting problems.


does the truck have any active codes, what is the fuel rail pressure getting up to while cranking, why did you replace the 2 injectors, why did you not put all six in? did you do this yourself, did you follow the correct procedure and properly torque everything. these engines are very sensitive to proper torque on fuel components.

Dec 30, 2010 | 2004 Dodge Ram 2500

1 Answer

Just fueled up 93 octane. drove approx 1/2 mile to work. started the car, check engine light came on and runs extremely rough and stalls. could it be the fuel and how do i check it. 2004 chrysler...


I would suspect the fuel is the problem, most likely water is in the fuel, but get the codes read to see what fault shows up that turned on the check engine light.

Oct 14, 2010 | 2004 Chrysler Crossfire

2 Answers

How do you get the check engine light to turn off or reset on dodge intrepid 2004?


Hi:
The light should be scanned first to determine the problem. Most auto parts stores will scan your car for free, and tell you what it is. Some causes are simple, like a loose gas cap, others are sensor related.

In a pinch, you can disconnect your car battery, but that isn't recommended, because it clears the memory on the computer, and all the adjustments the computer has made to make the car run better are lost too.

Nov 15, 2009 | 2004 Dodge Intrepid

1 Answer

2004 SX 2.0 (standard) everything turns on except the engine


It sound like the nutral saftey switch their is a swith thats connected to the clutch arm up under the dash. When you push your clutch in it tells the computer that it's okay for the car to start because it knows then knows that the transmission is disengaged and in nuetral for saftey reasons. It's a pain in the but to to sometimes depending on how much room you have to stick your head up under the dash. Get a flashlight and just push the clutch in and out you might hear it click to help you find it. It might be a little box conected to the arm itself or just a simple switch that just pushs in and out. I hoped this helped you out. It would be appreciated if you could rate my answer. Thanks, Good luck MIKE-

Jul 13, 2009 | 2004 Dodge Neon

1 Answer

Check engine light is on


It is mounted (OBD 2 connector) under the dash panel in front of driver and below approx center of steering column.

Mar 11, 2009 | 2004 Dodge Stratus

Not finding what you are looking for?
2004 Dodge Neon Logo

1,370 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...