Question about 1990 Honda CRX

3 Answers

1990 honda crx si, 1.6 transmission

Where is the dipstick on a 1990 honda crx si, 1.6 transmission?

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 145 Answers

No dipstick...you verify by havin car first on level ground then.Then when on stable ground remove the 17mm filler plug on upper passenger side of transmission.if fliud flows out of filler plug than level is fine.if does not flow out whenplug removed.RECOMMEND STRONGLY using a honda brand manual transmission fluid in this transmission..it does wonders for shifting or gearing issues.

Posted on Sep 13, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 32 Answers

There is none since its a manual. If youre planning on flushing it, use 2 quarts of 10w30 oil in it.

Posted on Nov 07, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

THERE IS NO DIPSTCK FOR THAT MODEL,IT ONLY HAS A FILL PLUG LOCATED ON THE TRANS NEAR THE INNER AXLE SHAFT A 17MM WRENCH IS WHAT YOU WILL NEED TO REMOVE THE FILL PLUG, THE MANUAL TRANSOIL SHOULD BE LEVEL WITH THE FILL HOLE WHEN IT IS FULL.

Posted on Sep 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the firing order for a 1991 crx si


the firing order for your 91 crx should be 1, 3, 4 and 2. You need to identify where the rotor points to when cylinder 1 is at top dead center.
Cylinder number 1 is the one closest to the accessory belts (alternator, power steering , etc, hope this helps.

Aug 10, 2014 | 1991 Honda CRX

1 Answer

Where is the transmission dipstick on a 1990 honda prelude si


I only know about the dipstick for the automatic transmission.
It is located to the passenger side of center and is burried dwon very deep - you almost have to reach full-arms-length down, between hoses and air duct to reach it. It has a wire loop handle usually covered in orange/yellow rubber. All total it is about 6 inches long when removed. It is so hard to find that I thought mine was missing and bought another one before I found it.

Jul 23, 2010 | 1990 Honda Prelude

2 Answers

1990 crx base model honda civic want start


I would suggest an ignition module. If it is a rough idle at startup I would check the throttle position sensor. You can check that by starting the car and unplugging the TPS. If the car runs differently then chances are it is working fine.

Dec 04, 2009 | 1990 Honda CRX

1 Answer

1990 honda crx si transmission trouble


this is not the problem of fluid, this is a major problem of transmission. The transmission must be detached from the engine, which you cant do by yourself. the transmission can be repaired but i dont know mechanics in your do it. otherwise you have to replace the transmission.

Aug 01, 2009 | 1990 Honda CRX

1 Answer

1991 honda crx si m/t almost impossible to shift after it warms u


Have you adjusted the clutch cable enough to allow it to disengage the clutch ? try that first. Is this the original clutch?

Jun 11, 2009 | 1990 Honda CRX

1 Answer

Cant shift in my 88 crx


I would recommend flushing the tranny fluid. you could go with GM synchromesh fluid found at the GM dealer and it will make the shifting buttery smooth. I use this all the time. appx 2 quarts.

Apr 08, 2009 | 1990 Honda CRX

2 Answers

Idles good but,above 1300 rpm serges evenly at about 3800 no more serge 1990 crx 16 valve 1.6 very strong serge


Have you replaced the fuel filter? if not, it could very well be the problem

Oct 14, 2008 | 1991 Honda CRX

1 Answer

1990 Honda CRX Si


therei sn't one the lights that you need are up under the carpet on the passenger side floor pull it up from th front turn on the key and count the blinks first the red one is like the tens one blink is ten two is twenty and so on the green is ones so three blink red is 30 and 4 blinks green the code would be 34

When you get your codes contact me and Ill tell u what they mean

Please give me a fixya rating Thank you Randy

Aug 20, 2008 | 1990 Honda CRX

Not finding what you are looking for?
1990 Honda CRX Logo

Related Topics:

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...