Question about 1995 Ford Ranger Supercab

Open Question

How do you flush a radiator on a 1995 ford ranger

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: how to flush the radiator on a 1995 ford bronco

I have a 92 Bronco and the plug on mine is on the passenger side lower corner. It faces the passenger seat & looks like a black wingnut.

Posted on Nov 09, 2008

Ad
  • 2 Answers

SOURCE: 1995 ford ranger coolant leak

frost plugs on the side of the block or something that you installed may have not sealed. can happen know the drill.

Posted on Feb 16, 2009

  • 1 Answer

SOURCE: ford ranger truck overheating

I have had this happen with my ranger. Changed everything I could to try to fix the over heating. It turned out that I had a small leak in my head gasket and it was allowing exsaust gas to go into the cooling system witch was over pressurizing it. Also the air from the exsaust will heat up much faster than liquid making your thermostat to read hot and will not be able to blow hot air in the cab because there is no liquid going to the heater core. This happened to me when my blet came off and I tryed to make it home. If you had it over heat for a long peirod of time it may have ripped the head gasket.

Posted on Feb 21, 2009

  • 881 Answers

SOURCE: my heater is not working in my 98 ford ranger what

YOU HAVE valve either under the bonnet ot under the dash board on or near the heater box and it works on vacuum and has a vac pipe connected to it so either that is your problem OR the thermostat is sticking and staying open it wont get hot BUTwill get warm only.

Posted on Oct 11, 2009

alicantecoli
  • 22156 Answers

SOURCE: Ford Ranger 1995 4 wheel drive issue

no it should have 12v i would have thought,but to be truthful i dont have a lot of experiance with this american type of vehicle ,land rover with levers yes ,double diff in a 8 wheeler yes ,12 speed foden gearbox yes.Would need to get my dirty mits under the bonnet to to sort it out .Sorry i couldnt be of any more help with a quick bang here or a thump their us brits would rather have a ford transit van diesel .with manual box and power steering .Now that a real mans tool ,ideal for carrying stuff

Posted on Oct 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why does my 1988 ford ranger f-150 over heat


Thermostat is stuck or the radiator or heater core is blocked up.

Apr 27, 2017 | Ford Cars & Trucks

1 Answer

How to change my engine coolant in a 1992 ford ranger-v6 3.0 engine, with what kind of coolant and how much of it


Hello again Vicki, you can read my first post to you on type. Now for where and how. Put suitable container under radiator drain valve. Start to drain old antifreeze, you can also loosen radiator cap for faster drain, but make sure antifreeze doesn't start to spill all over your driveway or garage floor. When radiator and engine are mostly drained, I would recommend to change the thermostat. Follow the top radiator hose down to the engine. This is where you'll find the thermostat. Remove the attaching bolts and remove thermostat.If you wish to flush your engine,you can put water down the thermostat hole as well as the radiator cap hole, or you can do a fancy flush. Shut drain below, reinstall thermostat housing without thermostat, fill radiator with fancy flush cleaning solution and water replace radiator cap ,run for time stated on can of flush. Now you go back to where I began and start the draining again. Dispose off antifreeze correctly it is dangerous to animals if they ingest. Close drain,and fill engine with antifreeze thru thermostat housing, when almost to top install new thermostat and gasket. fill radiator almost to top, start engine, open inside heater and let engine warm to operating temperature. At this time the antifreeze level will drop, because thermostat will open, and you can fill some more .This should eliminate any possible air bubbles. Fill your coolant tank. I would like to know how you make out. GOOD LUCK.

Oct 11, 2011 | 1992 Ford Ranger

1 Answer

Been settin for 5years will crank and hit but want start


I recommend a tune up to get it back to running good...
Oil, filters, plugs, radiator flush, brake system flush, ****** flush...check spark plug cables and replace if necessary.
Its a small expense, but it will make it run good and it will last...

Good luck

Aug 19, 2011 | 1985 Ford Ranger

1 Answer

83 ford ranger no heat ,new heater core,thermostat,blower motor,runs at normal temps,noticed one heater hose very hot yet the other one which is ran into a metal line going to the engine or ekg valve is...


it sounds like you have a air blockage, or the cooling system needs flushed. to flush system go to ( autorepair.about.com/od/regularmaintenance/ss/coolant_f...) click on 3rd one down. remember to bleed air out of system, this works the best. turn heater and blower on high, start adding coolant. start car let it idle till radiator thermostat opens. when top radiator hose gets hot you should have heat. some vehicles have a bleeder to let air from system. when filling putting coolant in system. if it does, then open bleeder while engine running and putting in coolant untill there are no air bubbles coming out. have a good day !! when doing flush if need be. you can go to any auto parts store and buy radiator flush. follow directions on the back ( prestone is best )

Dec 11, 2010 | 1983 Ford Ranger

1 Answer

1999 ford ranger overheating. have replaced


Have you had the radiator tested for emission blow by?
Radiator Specialists can be of assistance with this testing device. Will indicate if the head gasket is leaking and cause overheating.

Jul 05, 2010 | 1999 Ford Ranger SuperCab

1 Answer

1995 ford ranger coolant leak


frost plugs on the side of the block or something that you installed may have not sealed. can happen know the drill.

Jan 07, 2009 | 1995 Ford Ranger Supercab

2 Answers

How to flush the radiator on a 1995 ford bronco


if there is no plug then just pop off the lower radiator hose at the radiator. then the fluid will drain

Oct 30, 2008 | 1995 Ford Bronco

1 Answer

1998 ford ranger 4.0 liter auto. runs hot while driving and cool while at idle. i have changed thermostat and fan clutch. ANY IDEAS?


You could benefit from a tow package upgrade including a tranny cooler if you don't already have one. You might want to pressure test the radiator, those things aren't immortal, and depending on where you live and how you drive, 10 years on a radiator is pretty good. seriously, pressure test the cooling system and go from there.

Aug 05, 2008 | 1995 Ford Ranger Supercab

Not finding what you are looking for?
1995 Ford Ranger Supercab Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...