Question about 1996 Ford Explorer

1 Answer

Compressor does not engage .I disconnected the leads while the vehicle was running reconnected the leads and the compressor started to work but once i shut it off and tried again i had the same problem.I tried the same procedure again but still does not work.How much current should i be getting at the connection? This is the air conditioner compressor.What else can be the problem?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Hi. It sounds like it is low on gas and it needs re-gassing.

Posted on Aug 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

AC Compressor only coming on intermittently


have the rectifier checked , it may have blown if you disconnected/ connected leads with engine running
see link below. Think you may need a new alternator!

https://answers.yahoo.com/question/index?qid=20080419153731AAiycGz



https://answers.yahoo.com/question/index?qid=20080419153731AAiycGz

Jul 18, 2015 | 2005 Ford Expedition

1 Answer

A/C compressor is engaged even when turned off inside. battery also is being drained when car is not running.


Unplug the power lead from the AC compressor.If it stays locked up it a mechanical issue with the new Clutch. If it unlocks check the following. Look at the AC Relay. If it has fused or failed in the closed position the ac clutch will remain engaged. As I don't have the vehicle details I can't provide further details

Nov 08, 2014 | Ford Cars & Trucks

1 Answer

I tried to jump start my 1997 grand cherokee and was unaware the alarm was engaged, did this damage the vehicle...it won't start...why?


Not sure here as they can be a slight bit finicle on earlier models like this ,try disconnecting the battery and join the leads together for half hour then reconnect the battery and try again

Jan 27, 2013 | 1997 Jeep Grand Cherokee

1 Answer

I have a 1998 chevy cavalier, I was driing and the AC was working. I stopped and when I started teh car again a couple hours latter the AC was not working. The fuses are good and the comressor and dryer...


Did you check the AC relay? Usually located under the hood, try swapping it with another relay with the same part number that isn't required to run the vehicle. If the AC now works, then replace the relay. If not , then verify compressor operation. With the engine running, watch the compressor clutch while someone else turns on the AC control. The clutch should engage and begin to run. If not, then find the pressure cycling switch usually located on the accumulator. Disconnect the harness and jumper the contacts. With the engine off and the key turned on , turn the AC control on. You should now be able to watch the clutch engage and disengage by removing and replacing the jumper lead. If it does, then replace the switch. I hope this information is helpful. Thanks for trying Fixya.

Jul 04, 2011 | 1998 Chevrolet Cavalier

1 Answer

Bought a used 93 mazda protege.(as is) A/C compressor does not start or engage.. When warmed up and running large primary fan is on. I fouund aux fan fuse removed from fuse box.under hood. I also found aux...


Sounds like u have a bad fan for 1,Im sure who disconnected it may have found an expensive problem they didn't want to deal with (electrical, ac compressor etc) Good luck, have it ckd

Apr 07, 2017 | 1993 Mazda Protege

2 Answers

Starter motor on 1992 Ford Fairmont V8 stays engaged for a few minutes after startup. Even when you turn key off you can hear it turning over. Does starter need reconditioning? How do I remove it?


The stater solenoid has probably failed. That will require replacement of the starter. To prove that the problem is the solenoid NOTE the position of the 2 small wires on the solenoid. The next time the starter stays stuck engaged remove the small wires. If it continues to run then the stater has failed due to a stuck solenoid. If it stops turning after you disconnect the 2 small wires, you may have a bad ignition switch or a system short to another +12VDC wire some where inside the vehicle.

To remove the starter you disconnect BOTH Battery leads at the battery. Then you remove the large POSITIVE cable from the solenoiod and the 2 wires. After that you remove the 2 mounting bolts for the starter and pull it out.

It is OK to replace the starter with a rebuilt starter.

To install the replacement starter install the large mounting bolts. Connect the POSITIVE lead to the solenoid. Connect the 2 small wires in the original positions then reconnect the Battery. Positive lead first then the Negative lead.

Test starter... if nothing happens you probably got the 2 smaller wires reversed on the solenoid. If it woks.. Job well done!

Autozone or Napa usually have a starter for your vehicle in stock.

Thanks for using FixYa.

Kelly

Apr 14, 2010 | 1983 Ford Fairmont

1 Answer

1999 Mitsubishi Eclipse Spyder A/C Only Blows Hot Air


I would take it back to whoever replaced the module however, if you want to check for the problem yourself, Look for the AC compressor. with the AC turned off have someone start the vehicle, while watching the AC compressor have the person in the vehicle turn the AC on. If the clutch engages then you have lost your freon charge and need to have the AC unit serviced. If it does not start turn the engine off and check all the wiring connections going to the AC compressor. If all the connections are good start the vehicle, and have the person in the vehicle turn the control to cold and turn on the defroster. If the AC clutch engages then you have a bad ECM module or mis-programmed ECM take it back to be Properly programmed and repaired. If the clutch does not engage it is possible the AC compressor is bad. Take the vehicle to the Mechanic to have teh AC system checked to see why it is not engaging.

Aug 27, 2009 | 2000 Mitsubishi Eclipse

1 Answer

Air conditioning won't engage


To reset your AC compressor, you need to remove power for at least 15 minutes. After you reconnect, the compressor should turn on. If it does, immediately turn to high and try to add refrigerant. Best of luck.
Greg

Jun 01, 2009 | 1994 Cadillac DeVille

2 Answers

2005 Avalanche Cranking/Climate Control problems


DISCONNECT THE ECU FUSE FROM YOUR FUSE BOX. WAIT 15 SECS AND THEN RECONNECT AND START YOUR VEHICLE.

Aug 24, 2008 | 2005 Chevrolet Avalanche

1 Answer

1995 Cadillac Deville


In my 1990 Cadillac Deville there is a sticker that says that one can reset the computer that controls the compressor by disconnecting the battery for a few minutes and reconnecting.

Did you disconnect the battery to reset the a/c system?

The symptoms you are describing lead me to believe that there is a safety feature that prevents the compressor from engaging when the compressor has been run for any length of time without at least .5 lbs. of freon in the system.

You said that you had to run a hot wire to charge it up with freon. But, if you ran it without freon, it may have automatically invoked the 'safety' feature.

I have seen this happen on my 1990 cadillac. I haven't had any problems on my 1997 Cadillac Limousine, because I never had a low charge on that car.

Aug 08, 2008 | 1994 Cadillac DeVille

Not finding what you are looking for?
1996 Ford Explorer Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...