Question about Buick Cars & Trucks

2 Answers

2004 buick rendezvous wont go in to program mode for remote programing

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Buick Master
  • 14,589 Answers

Transmitter Programming
Important: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.
Install a scan tool.
Use the scan tool in order to access programming: Vehicle Control System/Computer Integrating System/Module Setup/BCM/Program Key Fobs.
Press the START soft key on the scan tool.
Important: The scan tool must stay connected until all of the transmitters are programmed.
Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of 5-10 seconds, the scan tool will indicate that the transmitter is programmed.
Repeat the previous step in order to program up to 4 transmitters.
Remove the scan tool.
Operate the transmitter functions in order to verify correct system operation.

Posted on May 10, 2018

Ad
  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Teacher:

    An expert who has written 2 tips or uploaded 1 video tip.

  • Contributor
  • 6 Answers

Below are the correct programming procedures for your 2004 Buick Rendezvous Remote. Timing is everything when you do these. If you fail, be patient and try again. All steps must be done within a pretty rapid succession.

Another thing to check is to make sure your vehicle is equipped with the "keyless entry" option. To find this out, give your local dealership a call, ask for service, then ask them if your vehicle came with keyelss entry. They will ask for your VIN number so have that handy.

For Buick Rendezvous / Intrigue / AztekObtain all remote transmitters for this vehicle.
1. Close all doors.
2. Press and hold the Unlock button on door lock switch on drivers door.
Hold until instructed to release in step 6.
3. Insert key into the ignition cylinder but do not turn it.
4. Remove key from ignition and then insert key into ignition without turning ignition cylinder and remove key.
5. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition.
6. Release door lock switch on drivers door panel. A Chime will sound 3 times indicating that you are in programming mode.
7. Press both the Lock and Unlock buttons on the remote up to 30 seconds.
A chime will sound 2 times if remote has programmed successful.
8. Repeat step 7 if you are programming additional remotes.
9. Remove key from ignition to exit programming mode.
NOTE: If you are having trouble getting this procedure to work, we have found that some vehicles need step 3 to be done before step 2.
Here is a great resource for key fob programming instructions https://www.keylessentryremotefob.com/Key-Fob-Programming-Instructions-s/1856.htm

Posted on May 24, 2018

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 9 Answers

SOURCE: program a garage door opener in 2004 buick rendezvous

I cannot find the 2004, but you can buy it from the dealer. You can download the 2003 and 2005 from this link. http://www.extendedgmwarranty.com/owners-manual/buick_owner_manuals.html

Posted on May 22, 2009

  • 31 Answers

SOURCE: I have a 2004 Buick Rendezvous but not the user

www.homelink.com will explain

Posted on Feb 07, 2010

  • 31 Answers

SOURCE: I need to program my new garage door opener to my

www.homelink.com for explanation

Posted on Feb 07, 2010

  • 51506 Answers

SOURCE: Can my 2004 buick rendezvous take full synthetic oil?

One would certainly think so . they even make it in a high milage type now .

Posted on Sep 13, 2015

Testimonial: "LOL Thank You Ray Gallant for your speedy response to my What the heck was i thinking question. :-)"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I program the keyless remote on a 2006 Buick LaCrosse


2006 Buick Rendezvous Remote Programming For Buick Rendezvous / Intrigue / AztekObtain all remote transmitters for this vehicle.
1. Close all doors.
2. Press and hold the Unlock button on door lock switch on drivers door.
Hold until instructed to release in step 6.
3. Insert key into the ignition cylinder but do not turn it.
4. Remove key from ignition and then insert key into ignition without turning ignition cylinder and remove key.
5. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition.
6. Release door lock switch on drivers door panel. A Chime will sound 3 times indicating that you are in programming mode.
7. Press both the Lock and Unlock buttons on the remote up to 30 seconds.
A chime will sound 2 times if remote has programmed successful.
8. Repeat step 7 if you are programming additional remotes.
9. Remove key from ignition to exit programming mode

Oct 28, 2017 | Buick Cars & Trucks

1 Answer

Rendezvous wont start with new key


I would suggest you have the key checked, as the chip in it probably wasn't programmed properly for your vehicle. Make a quick phone call to the dealer and they will explain it and what to do about it. Basically your key has a microchip in it that communicates with your vehicle. If they new key was not programmed for your specific vehicle, it will not start it.

Jul 09, 2014 | 2003 Buick Rendezvous

1 Answer

Buick rendezvous electric wont shut off after key is removed radio stays on and when you open door still has power with key out made the instruments in the dash act funny gas guage wont work lights stay on...


You need a new body control module. Located behind the center console under the dash. It can't be re-programed and needs to replaced with a new one that is VIN specific to your car. Dont get one from the junkyard, it wont work.

Aug 21, 2011 | 2002 Buick Rendezvous

2 Answers

I need to program my new garage door opener to my 2004 buick rendezvous I dont have my manual to tell me how to do it help


go to the brand of garage door opener and usually under support they should have manuals for your model

Oct 29, 2009 | 2004 Buick Rendezvous

1 Answer

Cannot program garage door transmitter


Depending on the type of vehicle home remote system you have and the type of garage door opener installed will determine how you program the system in your vehicle.
Below is a web address for the owners manual to your Buick. It will show you step by step how to set your Buick's remote system to open your garage door.
Good luck.
Regards,
http://www.extendedgmwarranty.com/owners-manual/buick/2007-Buick-Rendezvous.pdf

Sep 08, 2009 | 2007 Buick Rendezvous CXL SUV

1 Answer

How do I program my keyless remote for my 2002 Rendezvous?


1. Close all doors.
2. Press and hold the Unlock button on door lock switch on drivers door.
Hold until instructed to release.
3. Insert and remove key from ignition 2 times. Do Not turn ignition.
4. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition.

5. Release door lock switch on drivers door panel.
A Chime will sound 3 times indicating that you are in programming mode.
6. Press both the Lock and Unlock buttons on the remote up to 30 seconds.
A chime will sound 2 times if remote has programmed successful.
7. Repeat step 6 if you are programming additional remotes.
8. Remove key from ignition to exit programming mode.

Jul 23, 2009 | 2002 Buick Rendezvous

1 Answer

Can you tell me where the mode button is on the buick rendezvous 2003.


On a 2004 model, it is on the left of your steering wheel.

Jun 12, 2009 | 2004 Buick Rendezvous

1 Answer

Setting up keyless remote entry with a new remote


1. Close all doors.
2. Press and hold the Unlock button on door lock switch on drivers door.
Hold until instructed to release.

3. Insert and remove key from ignition 2 times. Do Not turn ignition.
4. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition.

5. Release door lock switch on drivers door panel.
A Chime will sound 3 times indicating that you are in programming mode.

6. Press both the Lock and Unlock buttons on the remote up to 30 seconds.
A chime will sound 2 times if remote has programmed successful.

7. Repeat step 6 if you are programming additional remotes.
8. Remove key from ignition to exit programming mode.

Dec 09, 2008 | 2002 Buick Rendezvous

1 Answer

Program a garage door opener in 2004 buick rendezvous


I cannot find the 2004, but you can buy it from the dealer. You can download the 2003 and 2005 from this link. http://www.extendedgmwarranty.com/owners-manual/buick_owner_manuals.html

Nov 04, 2008 | 2003 Buick Rendezvous

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

342 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...