Question about 2005 GMC Yukon Denali

Open Question

Traction Activated -- I have the same problem with my 2004 Denali

When I drive my 2004 GMC Denali, occasionally while accelerating, the Traction kicks in and slows the car down -- message on display says "traction activated". How to fix this problem... GM Dealers cant find problem - or just give up,.

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3600 Answers

SOURCE: traction active keeps coming on

TRY CHECKING THEW OIL IN THE DIFFERENTAL FRON AND REAR, IF IT'S LOW FILL AND SEE IF YOU SEE ANY FLUID COMMING OUT.

Posted on Aug 21, 2009

  • 16 Answers

SOURCE: sluggish acceleration traction light comes on

this must be a 2.3 miller cycle. it is going into "limp home" mode. when this happens, it wont rev over about 3k, and tcs off/tcs lites come on. it feels a lot like fuel cut. probably the check engine lite is also on, and what codes are stored? most common is P1525/26 and 1540, which are the solenoids that control the abv. the abv controls boost, and when this valve is not working proplerly, the pcm stops communication with tcm, and it goes limp home. if you can locate the solenoids, they are on the back of the engine, right next to the egr valve. from right to left, you need to look at the second and forth. you need to ohm them when they are hot. normal is around 26. if they are over 30, or 0, they are bad. there are other possibilities, but this is most common

Posted on Sep 01, 2009

  • 1 Answer

SOURCE: 03 Yukon Denali Traction Control/ ABS Problems

my 2000 yukon has the traction control light on and the abs light on any anwsers?

Posted on Nov 28, 2009

  • 11 Answers

SOURCE: i have an 06 gmc denali and the traction active

most likely a wheel speed sensor(abs sensor)has gone bad or it is not making a proper connection. you need to take it to a repair shop that has the proper diagnostic tool for it so that they can tell you which one of the four sensors is defective. hope this helps

Posted on Jan 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 GMC Envoy Denali, when I am driving especially in the snow or slick roads. My stabilitrack kicks off and I have no power in my gas pedal. Then I let it sit for a bit and it goes off, but as...


I doubt very much it is the accelerator pedal which is basically just a potentiometer to feed go faster/go slower information to the brain. These things tend to either work or not and don't usually play hide-and-seek.

On those vehicles equipped with anti-lock brakes the same sensor information can be used for an electronic stability control system to improve traction in poor conditions by detecting which wheel has lost traction and applying the brake on that wheel. If the system cannot cope the engine power output will be cut until traction is restored.

It would seem the system has a fault and should be checked out by someone familiar with that type of magic.

Mar 03, 2015 | 2006 GMC Envoy Denali

1 Answer

2006 denali traction control comes on when not needed?


its the sensor doing its job, takeoff leads to sensor adding power to both or all tires as needed. does it stay on when you reach cruising speed?

Jan 22, 2014 | 2003 GMC Yukon Denali

1 Answer

2003 Yukon Denali: Traction Control message


I HAVE NO IDEA HOW BUT I CALLED GMC they seem to care they keepcalling asking when i am king it to a dealer so the dealer can tell them what is wrong they claim if it is there fault they will help pay the traction control goes on at low speeds when it is not to go on i see i am not the only one with this and see not of the GMC dealers can find the fix looks like a recall that will not happen

Feb 21, 2010 | 2003 GMC Yukon Denali

1 Answer

Temperature and Traction Problem!


Yes you're good because they are DOT rated

Aug 07, 2009 | 2003 GMC Yukon Denali

3 Answers

03 Yukon Denali Traction Control/ ABS Problems


my 2000 yukon has the traction control light on and the abs light on any anwsers?

Jul 31, 2009 | 2003 GMC Yukon Denali

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...