A would try my local Ford dealer first, then I would try to go on-line because there are many businesses that will repair your :head" and return it to you by mail or a commercial carrier.
I have had good success with these myself.
God bless your efforts.
SOURCE: Oxygen Sensor Location 2001 Ford Expedition Eddie Bauer
There are four o2 sensors on this truck. one on each side just below the exhaust manifold, and one on each side behind the second catalytic converters. (just about even with the back of the front doors.
SOURCE: diagram bypass heater cord on 2001 ford expedition eddie bauer
the heater bypass is quite simple, if you look at the firewall you will see two medium sized coolant lines, remove them from the firewall and link them together using a proper sized tube, you can purchase a kit at a parts store quite cheaply
SOURCE: cd changer stuck
I had to take the changer out of the console and get the CD that was hung up. I then replaced everything.
SOURCE: How do I install a brake booster on a 2003 Ford
disconnect the neg batt cable,loosen clamp and disconnect air cleaner outlet tube and resonator from the air cleaner. 2.disconnect maf sensor connector. 3.lift air cleaner assy from tray and position aside. 4. remove screws from power steering resevoir, and position aside. 5.disconnect brake fluid level sensor, and if equiped brake pressure switch. 6.remove the two mounting nuts holding master cylinder, position master cylinder aside (DO NOT LOOSEN LINES ON MASTER CYL). 7.remove mounting bolts for degas bottle and postion aside. 8.if equiped diconnect wiring at the pedal position sensor. 9.relaease clamp and disconnect hose. 10.remove the pin, washer, bushing and switch, disconnect pushrod. 11.remove the nuts and brake booster, to access nuts fold back sound insulation. reverse procedure to install.
Testimonial: "Dude, you rock. Thanks for the info. I have done a lot of radiators, alternators, even a knock sensor on a maxima, but never this......thanks bro."
SOURCE: Location of Shift Solenoid in 1999 Ford Expedition Eddie Bauer?
They are round "cans" with wires attached. You should have SSA, SSB, SSC, Torque converter and Pressure Control solenoids. They control pressures and have no mechanical linkage.
271 views
Usually answered in minutes!
×