Question about Scion xB

1 Answer

2005 xb won't start ... New battery and new starter... Turn key and nothing happens.. Like securty problem... Or cluctch switch. Does anyone have an idea ??? Pmjsfl@yahoo.com

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Poss need new ECU onboard computer poss get second hand this has fixed same problem on vauxhall cavalier

Posted on Aug 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clutch switch bad


Clutch switch keeps it from cranking.
You can bypass the cluctch switch. Make double sure transmission is in neutral. On many jeeps, under the hood is fuse/relay box. One of the relays is the starter motor. Pull the relay. With a pair of pliers, take a paper clip and short the pins that go to starter. They wire can get hot. If the starter cranks, you might be right (see ignition switch and any interlocks - like clutch switch), if the starter doesn't crank, get a new starter.

Jul 07, 2014 | 2005 Jeep Wrangler

1 Answer

Car won't start


A mechanic would check for voltage at the starter, the neutral safety switch, and the key switch. Also check the ground connections.

Jul 30, 2012 | 1991 Plymouth Acclaim

1 Answer

2005 ford tauras car i turn key and nothing happens fully charged battery and new starter


fuses - including the eingine fuse itself,. otherwise you may want to tap on the starter while someone trys to turn it over,. otherwise remove, test (if good) replace starter) was the starter solenoid replaced with the starter? are all the connections including the battery ground cleaned/ inspected? You may have a bad starter or bad solenoid, even new (rebuilt) that can happen..
best regards
Ck

Jul 17, 2012 | 2005 Ford Taurus SE

1 Answer

Won't start


could be the neutral switch try and crank it while moving the shifter around also try and put power to the small terminal on the starter that will tell you if the starter is bad or the wiring or switches

May 23, 2012 | Cars & Trucks

2 Answers

2000 Pontiac Sunfire won't start


Try checking the oil, the low oil sensor will disable the ignition

May 29, 2017 | 2000 Pontiac Sunfire

1 Answer

I have a 95 buick-new battery-turn key & nothing happens-won't turn over&where is the starter located


The starter is where the engine joins the gearbox, usually on the engine side. Check that he wiring it connected at the starter and the ingnition switch. Make sure the battery terminals are good and clean and tight. Otherwise the starter solinoid may be faulty, or the starter itself.

Jul 19, 2011 | Buick Lucerne Cars & Trucks

1 Answer

I turn the key nothing happens? I have new battery, I put in a new starter, all the lights and bells work. The starter has been tested it'"s new. I changed ignition relayy switch still nothing It...


I have a 93 pathfinder SE 4X4 automatic transmission that had full power, new starter and battery. Sometimes it will start and sometimes not. By passed starter relay by adding push button start and it started 6-8 times then nothing. I finally figured out that it was the neutral safety or inhibitor switch on the 4 wheel drive shifter. Just an idea..good luck

Jun 20, 2011 | 1993 Nissan Pathfinder

1 Answer

I have a jeep tj 4.0 2005. When I try to start it nothing happens. The starter does not turn and i have changed the battery for a new 1. I have checked my grounds on my starter and also the fuse ive...


First, using a digital volt/ohmmeter, check the power at the main lead on the starter. It should read full battery voltage. If not check all connections at the battery and to the starter. Next, check the small trigger wire on the starter with the key turned to start. There should be 12v there as well. If not, Check the starter relay and the ignition switch. If you have 12v at the main wire and the trigger wire, replace the starter, providing that you can turn the engine by hand.
I can't tell you what has failed but I've just told you how I'd find the problem.
Good luck!!

Oct 15, 2009 | 2005 Jeep Wrangler

2 Answers

Won't start getting nothing when i turn key


Recheck all your connections, battery. starter, look for fuseable link on small wire going to starter. Might want to chk.that wire with test light when key switch is in start position and see if it lights. If it does not light might be starter switch under dash on steering colume.

Apr 01, 2009 | 1983 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

413 people viewed this question

Ask a Question

Usually answered in minutes!

Top Scion Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Brad Brown

Level 3 Expert

16621 Answers

Are you a Scion Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...