Question about Mitsubishi Galant

Open Question

My idle is 2 high and 1st gear cuts out. do i need to change spark plugs or leads? or is my carburetor blocked?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my vehicle sluggish uphills.


Could be in need of a service air filter blocked ht leads or plugs badly fouled up or mass air flow needs a good clean.

Jul 20, 2015 | Cars & Trucks

1 Answer

Nissan vanette cuts off while driving and hard start on mornings


Check your float level in carb. & test the valve with the float, check your fuel filters and check your fuel line from the tank or check for dirt in base of tank, lastly check your HT leads to plugs

Sep 22, 2014 | Cars & Trucks

1 Answer

Ford v6


First, do a tune-up. Make sure your air filter is clean and the idle air passages in the carburetor are clear. I assume at one the idle mixture was properly set, so if it's no longer idling properly, something else has changed. Fouled plugs or bad fuel could be a cause. In particular, ethanol-blend fuel that has been in the tank for several months will not work well in engines without electronic controls.

Jun 25, 2014 | 1971 Ford Cortina 1300

1 Answer

Hi, I have an Opel Monza, 1.8 GLE 1987 model with carburetor. When accelerating uphill, it drops revs and wants to cut out or just cuts out and I battle to start it. It also jerks a bit when I drive i


hi Yvette! from what you are describingi think thats the fuel pump that is going to die very soon to your hands.i suggest if your mechanic has a spare one to replace it and make some test runs himself,before he delivers it to you!

Feb 05, 2014 | Cars & Trucks

1 Answer

2002 Mazda Protege 5 with 102K. Very rough idle, almost stalls. In any gear, warm or cold.


This vehicle's most common issue is the High Tension spark plug leads and coils, so check these first, as well as condition of the spark plugs.

Nov 15, 2012 | Cars & Trucks

1 Answer

My outboard motor doesn't idle at low rpm's, it cuts off when put into gear.


Could be several reasons for this, poor quality / dirty gas, restricted fuel line either partially blocked or pinched at some point come straight to my mind.

May 02, 2017 | Cars & Trucks

3 Answers

High idle at first start


quite normal as the vehicle has a auto matic choke,
once the engine starts warm up so the idle rate comes down "youdoit"

Oct 26, 2009 | 2006 Toyota Tacoma

3 Answers

93 jeep cherokee , iv got spark at the coil but not at the plug just replced cap, roter, wires, but still notheing got any ides ?


Coil may be producing low voltage (KVs) to where it makes enough energy to snap out of the coil tower but then supressed as it travels down the high tension leads finally to the plug. Incidentally spark plug leads should have about 10k ohms of resistance per foot.I good coil will jump spark at least a half inch if you pull the wire off the cap and produce this much air gap

Aug 26, 2009 | 1993 Jeep Grand Cherokee

1 Answer

Idle flucutation rough take off in 1st and 2nd gear


The spark plug leads in these cars are notoriously bad. I would change them without hesitation just for maintenance if nothing else, but I bet it solves your problem.

Mar 16, 2009 | 1990 Mazda MX-5

1 Answer

Carburetor problems 1989 honda accord lx


Carburetor on a 2002??? Do you mean throttle body? If you changed the throttle body to a different brand or size then your car's cpu should be reprogrammed.

Oct 18, 2008 | 2002 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...