SOURCE: 2006 Nissan Murano is Stalling when trying to accelerate
there is a problem with your vehicle and its transmission valve body.this will cause this type problem and it will store a code in the tcm,but wil not illuminate on the dash,this is the only problem i can find that mentions these type symptoms,please see a qualified nissan tech,and have your vehicle scanned for these codes;po868,po840
SOURCE: 2005 Nissan Altima cuts off while driving.
Dear Tajack73: Nissan had a voluntary recall campaign on the 2002,2005,2006 Altima's with the 2.5 litre engines It envolves reprogramming the ECM.
The campaign ID # RD0712 NHTSA #: 07V-527
2005 Altima Vin's 1N4AL11**5C 100003-957025
1N4AL11**5N 400000-934180
The symptom you have described fits the one they have describe in the bulletin. Check with Nissan and see if your car falls within the campaign. Let men know how you do.
SOURCE: hesitation or jerking when proceeding forward
Remove the mass air flow sensor and clean it.You can get mass air flow sensor cleaner at most part stores.The sensor is on the air cleaner tube that goes into the throttle body.Hope this helps.Good luck.
SOURCE: 2005 frintier crew cab hesitate
Sounds like your ECM relay. They are one recall on some 2005 Frontier trucks.
SOURCE: 87 T-bird hesitating
1987 t-bird 2.3 turbo coupe Car starts and idles, starts a little hard but idles wont rev past 1000 rpm when you push throttle to the floor the car dies checked fuel pressure at the rail 40-42 pounds. Could it be the throttle position sensor? where should I go from here
490 views
Usually answered in minutes!
×