Question about 2001 Dodge Intrepid

2 Answers

Car starts normal but when put in reverse or drive, stalls and shuts down?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 1 Answer

Could be a bad crank/ cam sensor

Posted on Dec 17, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 144 Answers

It sounds like the automatic transmission converter may be locked up.

Posted on Aug 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford Excurtion will start normal, but stall when putting in gear (reverse) or braking. When re-starting it runns ok until next braking.


Have the catalytic converter checked at your local muffler shop...clogged...worn out...Hope this helps.

Mar 12, 2014 | 2005 Ford Excursion

1 Answer

My 1990 nissan 240sx started to just stall out when I come almost to a complete stop and when I put in reverse if i dnt punch on the gas it will stall then it wont start rite away it takes a while then...


Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Sep 13, 2012 | Cars & Trucks

2 Answers

I start my van and put it into reverse or drive and it stalls out sometimes while i'l driving and then it wont start agan... HELP


If you knock gently under the fuel tank for about 5-6 times and then start your vehicle. If it starts, then 100% it is time to replace the fuel pump. Good luck.

Jul 29, 2012 | 1996 Plymouth Voyager

1 Answer

If you put your car into reverse while driving


It shut the engine down. You started it back up and it works?

Jul 18, 2010 | 2006 Chrysler Neon

1 Answer

When put into drive the car shakes and stalls. It


I have a 1989 5-series BMW which sometimes stalls after changing from reverse to drive. It also sometimes shakes when first driving in reverse before changing to drive.

Jan 30, 2010 | 1992 Mazda Protege

1 Answer

Car keeps stalling when brakes applied, then starts but turns off


I dont know why, but one time my truck was low on trans fluid and after I topped it off, it didnt stall anymore when put into gear. as fro the odometer i dont know, it may have to go out completely before any diagnosis can be done.

Oct 13, 2009 | 2001 Ford F150 Styleside SuperCrew

2 Answers

I hace 02 pt cruiser. while in reverse engine shut down when foot is taken of gas


you might have some wire toughing the ground rabbing when put it in reverse the eng shiftting causing wires to stretch and might touching ground or hot wire

Jul 20, 2009 | 2002 Chrysler PT Cruiser

1 Answer

91 camry starts and shuts off when put in drive or reverse


I was an ASE master auto tech for 13yrs and have seen this problem before. It sounds like the idle air control valve on the intake manifold has stopped working and the idle speed is not being controlled(letting the engine idle too slow which causes a stall when put under a load such as putting it in gear). Try giving it a little throttle while putting it in gear if that works let off the throttle if it dies you will know the Idle Air controll is not working.

Oct 12, 2008 | 1991 Toyota Camry

1 Answer

Car stalling out


Look to the CAT convertor. This is the important one. It is probably plugged and the car is not safe to drive with the plugged CAT. The CAT convertor looks like a muffler under the car.
Bill

Oct 03, 2008 | 1998 Nissan Altima

Not finding what you are looking for?
2001 Dodge Intrepid Logo

Related Topics:

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...