Jeep grand cherokee 2002, red light on cluster left top corner, looks like fuel pump, what does it mean

SOURCE: setting timing on a 2002 jeep grand cherokee

how do you set the timing on jeep laredo 2002?

Gary Queen

• 85 Answers
• Posted on Nov 15, 2008

SOURCE: change water pump

If you have any questions feel free to ask. Let me know if you dont get diagrams(happens sometimes)

Reverse rotation water pump—2.5L and 4.0L engines

1. Before servicing the vehicle, refer to the precautions in the beginning of this manual.
2. Drain the cooling system.
3. Remove or disconnect the following: NOTESome 4.0L engines are equipped with a fan clutch that threads Directly on to the water pump shaft. This fan clutch is equipped with right-hand threads. NOTEDo not store the fan clutch assembly horizontally, silicone may leak into the bearing grease and cause contamination. NOTEOne of the water pump bolts is longer than the others. Note the location for reassembly.
   • Negative battery cable
   • Electric cooling fan connector
   • Accessory drive belt
   • Engine cooling fan and pulley
   • Water pump pulley
   • Power steering pump
   • Lower radiator hose from the water pump
   • Heater hose
   • Water pump and discard the gasket

1. Clean the mating surfaces of all gasket material.
2. Install or connect the following:
   • Water pump using a new gasket. Torque the bolts to 17 ft. lbs. (23 Nm).
   • Heater hose
   • Lower radiator hose
   • Water pump pulley. Torque the bolts to 20 ft. lbs. (27 Nm).
   • Power steering pump
   • Engine cooling fan and shroud. Torque the bolts to 31 inch lbs. (3 Nm).
   • Accessory drive belt
   • Electric cooling fan connector
   • Negative battery cable
3. Fill and bleed the cooling system.
4. Start the engine, check for leaks and repair if necessary.

1. Before servicing the vehicle, refer to the precautions in the beginning of this manual.
2. Drain the cooling system.
3. Remove or disconnect the following:
   • Negative battery cable
   • Fan and clutch assembly from the pump
   • Fan shroud and fan assembly. If you’re reusing the fan clutch, keep it upright to avoid silicone fluid loss!
   • Lower hose
   • Water pump (8 bolts)
4. Installation is the reverse of removal. Tighten the bolts, in sequence, to 40 ft. lbs. (54 Nm). Water pump tightening sequence—3.7L

SOURCE: 2002 jeep grand cherokee. Rear left brake light isnt working

The problem with your tail light is the housing is broken where the socket goes in. If you pull that socket out and look you will see the metal tap will be pushed down and the plastic around that will be broke. Easy fix is to replace the lens but you can get under the metal tap with a small flat tip screw driver and pull up on it very lightly and it should work for awhile.

Hope this helps
Cory

SOURCE: airbag light is iluminating on the instrument cluster

have the jeep scanned by a dealership NOW!!
unless you dont mind driving with the airbags disabled!!,
--you basically have an error with the air bag system!!,
and can only be diagnosed by the dealer's scanning software,(welcome to new age cars!)

SOURCE: How do you program a 2002 Jeep Grand Cherokee FOB?

if you have an original working fob and your owner's manual,it will explain procedure,otherwise will have to go to dealer to be programmed