If the other seat positions work ok, then it sounds like voltage and ground are ok.
I don't know what testing you've done?
The horizontal motor, to move back, lite green wire is voltage. tan wire is ground, need both. You can use a test light to check voltage and ground.
I don't how difficult to get at those wiring circuits? Some makes and models, I'll remove the seat to do testing. Then you can use jumper wires off the battery for the horizontal motor, if the motor is the problem. I can only help with testing.
SOURCE: front seat does not slide back evenly. seat is **** eyed.
take off the seat pull both tracks out as far as they can go .see if both same distance out .now fitt the seatmaking sure tracks have moved.fitt two front bolts then push seat and fitt two back bolts
SOURCE: cannot access rear bolts as power seat stuck in
Bolts should go through the floor with a nut underneath the car. No need to try to access from inside.
SOURCE: 2008 impala stuck in park, no problems previously.
put foot on brake pedal then change positions on selecter!
SOURCE: back driver door won't lock
Hello, this is caused by a bad door lock actuator. the door lock actuator is part of the door latch. the door latch will need to be replaced to correct this problem.
118 views
Usually answered in minutes!
×