Question about 1999 Chevrolet Suburban
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2000 Tahoe Horn broken
You can remove the horn relay and use a Ohm meter and check the resistance between the horn relay connector terminal No. 86 (Black Wire) and ground. If the ohms are less then 5 ohms replace the horn relay. There are a lot more tests but as Polarcycle states you can do what he suggested other then I believe you have two horns in this vehicle.
Posted on Aug 03, 2009
In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to follow factory Airbag disarming protocol can result in an unexpected Airbag deployment and possible serious personnel injury or death.
Posted on Aug 04, 2009
SOURCE: 2001 Suburban Horn not working
Dealers charge approximately $75-90/hr. labor. The horn pad repair, labor-wise, can easily run 2 hrs labor plus parts. Unfortunately, the horn buttons in the pad are flimsy and break easily. This could result in more repairs later. An alternative fix, if you are not fussy about appearances, is to nount an external horn button on the dash within reach of the driver. This is legal for inspection puirposes in MOST states (check local laws). You can cut into the horn wire where it comes out of the steering column, or you can ****** it at the horn relay, whichever is more accessible. The horn button can be obtained from any auto oarts store, and will be a more permanent repair. Also, no airbag worries. While working with the wiring harness, avoid any YELLOW wires. These are normally airbag wiring.
Posted on Nov 26, 2011
(Inside the drivers door on the door latch is a switch called the door ajar micro switch, it is defective. With no signal from this switch the system triggers the alarm system. You must have this switch input checked, it can be the switch or the wiring to it that is defective.
Posted on Jun 27, 2012
Tips for a great answer:
Nov 28, 2017 | 2002 Honda CR-V
Apr 01, 2016 | Toyota Cars & Trucks
Mar 08, 2016 | Cars & Trucks
Sep 04, 2012 | Chrysler PT Cruiser Cars & Trucks
Aug 23, 2012 | 2006 Acura TL
Dec 03, 2011 | 2006 Hyundai Sonata
Nov 17, 2011 | 1994 Buick LeSabre
Feb 25, 2011 | 2008 Chevrolet Impala
Mar 10, 2009 | 2000 Ford Focus
111 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: