Question about Toyota Pickup

1 Answer

Lost a belt from the engine while driving but not sure what it was for in the first place. fan runs. not overheating. power steering and brakes still work. Would you have a diagram of the front of an engine for a 1991 Toyota Liteace (Japanese import) van? Thanks

Posted by on

  • levbeck Aug 01, 2009

    Thanks for the info but it's not a serpentine belt. It looks like this is one of 3 belts - is that possible or am i imagining things?
    What would i notice if I'd lost one of these belts?
    The power steering and brakes and fan still work and the van hasn't overheated or gone hot.
    ??
    Thanks again,
    Lev

  • levbeck Aug 01, 2009

    Hey again,
    Those schematics all show serpentine belts.
    This belt is pretty short and I'm pretty sure it only drives one set of pulleys.
    Thanks,
    Lev

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 8,619 Answers

Hi

Thanks for using FixYa. Please check if its not A/C fan belt or radiator fan belt. Please look at the following links that will show you the belt diagram--

1991 Toyota Car Belt

Also see this link fro details--

Belt schematics

Toyota belt connections

Please do accept the solution if the issue is resolved or else revert for further assistance.

Thanks
Rylee

Posted on Jul 31, 2009

  • Rylee Smith
    Rylee Smith Aug 01, 2009

    Hi Lev,



    I believe you did not click on the links that I send you with the belt description and schematics, as it could not be anyother belt apart from those diagrams that I have sent you.



    Please check and revert for further assistance.

    Thanks
    Rylee

  • Rylee Smith
    Rylee Smith Aug 01, 2009

    Lev there is no other belt which if breaks can cause a damage as you already know it has not caused anything. I believe you could have looked at something else.



    Please revert for further assistance.

    Thanks
    Rylee







×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I was driving down the road and lost power..no gas..no brakes...no steering.


did it restart?
the engine stalled, as such you
get
no engine power
no P/S reverts to manual steering, you did not loose steering.
same with P/B power brakes, you didnt lose it you lost power
assist, brakes will stop just as vast but takes a husky foot.
in school (driving) we were though to drive, stalled engine.
i guess most school went dumb. (seen it)
now stalls
engine stall for a vast number or reasons.

do that tuneup not called the 60k mile service point list. did you.?
cars ignored all fail, no car runs 300k miles service free,
skip them and get stranded, (i promise)

1: lost electric power to the EFI system.
2: engine overheated or lost compression for any reasons (complex)
3: lost spark
4: lost fuel
5: too much fuel, flooding, and stalling.
6: egr sticks open.
7: ISC sticks closed.
8:if not restart, say so and list expands way more...

cars are complex, it's not like a burned out desk lamp.
vast complexity and after 2007 , insane complexity.
avoid them 2007 and newer, sans NASA engineer.

Oct 12, 2013 | 2002 Chrysler PT Cruiser

1 Answer

Battery light and abs light on hard to steer overheating


sounds like you either lost your fan belt, or you have a seized up alternator, or belt tensioner. The fan belt [ drive belt ] turns the alternator to charge the battery, the power steering pump to make easy steering , and the water pump cooling your engine. Do you smell rubber burning? hear a squealing noise? or rattling noise. Open your engine bonnet, start the car up, and look at the drive belt and pulleys. They should all be turning. If this is the problem you will see something seized up. Also if you have let the power steering pump run out of oil, it may also be seized. Good luck with it

Jan 01, 2013 | Hyundai Cars & Trucks

1 Answer

What is wrong with a vehicle when the battery light comes on but the engine is still running but the power steering has lost power


Sounds like you lost your drive/fan belt. Check to see if you still have a belt on the vehicle.

Dec 26, 2011 | Cars & Trucks

2 Answers

My chevrolet astro lost power steering and the brakes are hard


Your van sounds like it has hydro-boost.It uses the power steering for brake boost instead of engine vacumme.More than likely you have had a power steering pump failure.

Apr 24, 2011 | 1997 Chevrolet Astro

1 Answer

1995 was squealing, then started to over heat. The dash lights that lit were, brake and battery. I lost power steering. I put water in radiator the temp dropped, but still no power steering and dummy dash...


Of course any belts that are missing should be replaced. If the engine overheated you probably do need to replace the thermostat as the temper has been changed.

Jul 26, 2010 | 1995 Mitsubishi Galant

4 Answers

1st I heard the power steering whine while I was going straight down the highway at about 70mph. Then the check gauges buzzer alerted me to the temperature getting really high. I pulled over and let it...


You probably lost the shaft bearing and seal in the pump. Replace the pump as it probably has damaged internal parts as well. Is this an engine driven fan or an electric one? If the engine tossed the belt during this event, it may have caused the fan to become damaged. If an electric fan, the shaft may be bent--replace the motor. If engine driven fan, you will need to disassemble it to find it's problem. Inspect the drive belt(s) for wear or damage. Recheck for proper cooling action after everything is back together.

Aug 24, 2009 | Dodge Ram 1500 Cars & Trucks

1 Answer

I was driving my car and when turning i lost my power steering and brakes when i parked i turned off the engine and after that it wont restart. later on we found that the sparks wernt getting any fuel but...


Question?? did you lose your serpentine belt, so your lost your power steering and then the engine died. Or did the engine die and then you lost the power steering??? If the engine died, may be the fuel filter has reached the end of it's life and dirty and needs to be replaced, If the engine was running and you lost the serpentine belt, the belt may have taken out your crank shaft sensor, so the engine does not know when to command the #1 injector to fire to get the engine to start. Keep me posted, be glad to help you get your car running

Jul 04, 2009 | 1996 Chevrolet Cavalier

2 Answers

Lost power steering and brakes


I'd say you broke a serpintine belt if you lost them both at the same time. Check your belts and see if you're missing one... You should have breaks and steering, just manual... hard to steer and brake...

Jan 07, 2009 | 2008 Dodge Ram 3500

1 Answer

Serpentine belt diagram for a 5.9 diesel with air and 9 pulleys


5.9L DIESEL
196759.jpg The 5.9L diesel engine accessory drive system (with a/c) consists of :
  1. Generator Pulley (1)
  2. Water Pump Pulley (2)
  3. Idler Pulley (3)
  4. Power Steering Pump Pulley (4)
  5. Radiator Fan Pulley (5)
  6. Crankshaft Pulley (6)
  7. Automatic Tensioner (7)
  8. A/C Compressor Pump Pulley (8)
CAUTION: When installing the accessory drive belt, the belt must be routed correctly. If not, engine may overheat due to water pump rotating in wrong direction. Refer to or for correct engine belt routing. The correct belt with correct length must be used.
1. Position drive belt over all pulleys except water pump pulley. 2. Attach a 1/2 inch ratchet to tensioner.


196757.jpg The 5.9L diesel engine accessory drive system (without a/c) consists of :
  1. Generator Pulley (1)
  2. Water Pump Pulley (2)
  3. Idler Pulley (3)
  4. Power Steering Pump Pulley (4)
  5. Radiator Fan Pulley (5)
  6. Crankshaft Pulley (6)
  7. Automatic Tensioner (7)
3. Rotate ratchet and belt tensioner clockwise. Place belt over water pump pulley. Let tensioner rotate back into place. Remove ratchet. Be sure belt is properly seated on all pulleys.

Sep 13, 2008 | 2008 Dodge Ram 3500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...