Question about 2001 Volvo S60
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Replace timing belt on Volvo S60
There is no room for error...... Zero clearance. If off one tooth it can and will bend valves. if you are one that just feels the need to get alittle dirty or just can't pay for the service, then get out your Haynes out and turn to .....Tune up, and look at replacing timming belt. Get a cam gear tool that locks them into place so as that they will not move when u have them lined up. make sure they are lined up with marks as said in book. then make sure crank as well as all marks are lined up acordingly. make sure belt marks are lined up with everything. i would reccomend using a volvo belt though cause it will have all the marks on it.However other company's make good quality belts also at a fraction of the price. So it is really up to you.
Good thing when doing timming belt is to also change out your timming belt tensioner. YES do this it will save you a engine in the long run. it is a moving part that will go bad, it will freeze up and snap timming belt. rip out teeth in thebelt and bend valves. So as a gen rule...When you change timming belt, Change belt tensioner at same time since you cant just change tensioner without changing or getting timming belt off. Remember to use your HAYNES. It is your friend and will save you money in the long run. Good luck... Hope this helps you.
Posted on Apr 08, 2009
SOURCE: check engine light code PO442
You likely won't notice any drivability problems. P0442 indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter.
The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage.
Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.
With a P0442, the most common repair is to Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, replace the gas cap, or Inspect the EVAP system for cuts/holes in tubes/hoses.
Good luck and hope this helps
Posted on May 07, 2009
SOURCE: volvo s60 idle sensor
if you could get your hands on a scanner to read some live data it would help your plight,there is a cam position sensor when you take of the the plastic head cover at the timing belt end,did you check plugs,it also might help to clean the maf with some contact spray,sounds like plugs
Posted on May 27, 2009
SOURCE: Volvo S60 sensor ?
Sounds like an oxygen sensor (there are two). I had a recent problem where I had a rough idle and my S60 continued to stall out. Turned out to be the rear oxygen sensor. After replacement, car idles nicely and car drives normally.
Posted on Jun 30, 2009
Tips for a great answer:
Nov 12, 2014 | 2009 Volvo S80
Jun 11, 2012 | 2001 Volvo S40
Jun 09, 2012 | 2001 Ford Explorer
Sep 02, 2010 | 2001 Volvo S80
Oct 27, 2009 | 1984 Volvo 240 Series
Sep 24, 2009 | 1988 Volvo 740
May 27, 2009 | 2001 Volvo S60
Nov 08, 2008 | 2001 Volvo S60
155 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: