Question about 1996 Jeep Grand Cherokee

1 Answer

Need to wire in plug to heater/ac control wire colors don't match need wiring diagrams to cross referance

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jeep Master
  • 17,970 Answers

Check tgis documents: ZJ-Secc-8W-Wiring-Diagrams ( INDEX Page 8W-35 )

Good luck and dont forget rated me.

Posted on Aug 04, 2009

  • Judy Aug 22, 2012

    Hi! I also need a wiring diagram for the Jeep Grand Cherokee 1996 Laredo 4x4 V6 AC wiring but the link above doesnt go there. Can you help me?



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Does the two plugs fit together? Wiring color will not match as aftermarket speaker wire use light grey, dark grey, green, and purple where factory wire uses blue, green, dark blue, and tan

Aug 29, 2017 | Geo Cars & Trucks

1 Answer

Speaker wiring diagram for a 08 dodge 2500 truck with 7 speaker infinity

Never have found good wiring diagrams for stereo's. Bought them and color codes didn't match. I have mitchell and alldata at work, they don't match. I wire them in with a volt/ohm meter. I find B+, Then hook ignition the the heater control wire. Ohm out the speakers. Thing is, you have infinity. You'll have to find the amp and cut the speaker wires and patch them there also, first. Just a note.. All speaker wires are twisted/paired wires. Cut the tape back 4 to 6 inches to find them. Another note. The speaker wires from the stereo to the amp will be a set of colors. From the amp to the speakers will be different colors.

Nov 01, 2016 | Dodge Cars & Trucks

1 Answer

Can't figure out how to wire up my trailer

You will need a ground wire first.
If you have a car built in the USA since about 1985, you have separate ground wires all over the car to each electrical component. You will need to find one and add a wire for the trailer so the trailer electric will be grounded to the car.
The ground wires on 4 prong flat plugs are white in color.
If your car is older than that, you can drill a hole in the metal frame and attach the ground wire to the frame at the rear of the car.
Next do the taillights.
Find the hot wire to the taillight on either side or to the license plate light and add a wire to that one to go to the trailer.
This wire is usually brown if you are using a flat 4 wire plug set up.
The next wire is the left turn signal, that wire is usually yellow in color, Finally, the right turn signal wire is green.
Understand you can have a real conflict if the trailer light do not match the car lights.
In that case, you may need to buy an adapter to make them work. What I mean is, if you have a separate bulb on the car for the turn signal and for the brake light, that will not match most trailers, and you will need to buy an electronic adapter.
God bless your efforts.

Nov 11, 2017 | Cars & Trucks

1 Answer

Just replaced plugs and wires on a 95 chevy camaro v6 now has no power

Sounds like you may crossed up some plug wires? use the diagram below to check this out as the poss problem. Match the numbers on the coil pack to the cylinder numbers. Cross wiring plug wires is the most common thing that home mechs do that they get wrong.


Feb 16, 2012 | 1995 Chevrolet Camaro

1 Answer

Hi I"m going to update

Your car must have the on-board computer with the more elaborate bulb-out sensor system because the wire colors you describe do not quite match the wiring diagram in the Bentley manual. Bentley does not show a "with check control module" front corner light which either means that they overlooked it, or it should be identical to the "without check control module" version.
According to the wiring diagram I have, the corner light should have a: A brown wire (ground), either Left Turn - A blue/green [blue with green stripe] wire Right Turn - A blue/brown wire and Left Park - A gray/violet wire Right Park - A gray/yellow wire
The only red wire I see in the diagram powers the relay for the fog lights.
Bentley is the best commercial manual there is, and should match the factory manuals, so I fear that you will need to use a voltmeter or test light, or trial-and-error your connection. If you have a voltmeter or test light, you can stick a needle through the insulation on the wire to test it to see if it is hot.
Based on my wiring diagram, I'm guessing that you don't want the blue wire, but that is just a guess.

Jul 08, 2011 | BMW 328 Cars & Trucks

2 Answers

When i turn my heater's fan on high nothing blows but when i turn the fan down a notch it blows again, i change the heater control switch twice and it didnt solve my problem whats wrong?

Check your AC Blower relay,trace the purple wire that plugs into the blower motor back to were it plugs into a rectangular box just 6 to 8 inches away.

Oct 11, 2009 | 1984 Chevrolet Monte Carlo

1 Answer

Non of the color codes match my car

If none of the codes match then the spot you are retrieving them from may have been changed, your local dodge dealer can cross you VIN# and find the cade. Or the Paint shops have camera's that can take a pic for the exact match.

Jul 19, 2009 | 1991 Dodge Dynasty

1 Answer

Heater/AC controller failure

If you dont have your 5v reference then no amount of modules is going to do you any good. Get a diagram trace your wire back and i'm betting you will find it fried to a crisp somewhere along the line, but make sure you check your fuses first. start simple and work into it. GOOD LUCK!!!

Feb 18, 2009 | 1991 Chevrolet C1500

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides