Question about 1991 Honda Accord

1 Answer

Engine rotates but will not start. I wait some time and then starts.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 133 Answers

Try the main relay.

http://www.fixya.com/cars/t591833-92_accord_occasional_no_start_problem

heres the forum on it.

Posted on Aug 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have just bought 2000 Proton Satria, I would like to know if the fans at the radiator to help cool the engine are temperature controlled to switch on or are they supposed to be running from the moment...


yes, they are made that way, if you want to make sure, just wait til it warms and pop the hood, and maybe turn fan switch to low thsat way it will need to start the fan to keep motor cool good luck

Jan 28, 2014 | Cars & Trucks

1 Answer

Toyota 4runner problems


check for an over heating situation with the motor as what you say indicates engine over heating.

Jan 23, 2014 | Cars & Trucks

1 Answer

1998 plymouth breeze that will not start


sounds like you jumped a tooth on your timing belt/chain. the wait to tell is first identify number 1 cylinder, then find number 1 on your cap, place a peace of tape right next to it or mark it with a sharpee marker or scribe a mark, however you do it mark it so you know where it is once the cap is off. then remove the cap and rotate the crank until you are at TDC (top dead cylinder) once there look at the rotor, if its not pointing at your mark than your valve timing is off and you need a new timing set. (if you cant find top dead then remove the valve cover and rotate the engine until all the valves on the number 1 hole are closed. once they are all close this indicates the compression stroke and number 1 is at TDC)

Feb 12, 2012 | Cars & Trucks

1 Answer

On my 1991 mercury capri turbo 1.6 put new timing belt on still wont start my question is. does it matter which way the cams go other than lining the timing marks up


The cams make 2 complete rotations for every 1 rotation of the crank so you could be out of time by 180 degrees.With the valve cover off turn the engine over by hand. As #1 piston comes up on TDC the intake valves should be open and starting to close. As you go past TDC the exhaust valves should start to open. If this is not what is happening in this order then your timing is off. Your engine should be at TDC when the timing marks are lined up with the marker on the engine. Hope this helps.

Aug 14, 2011 | 1991 Mercury Capri

1 Answer

My 2005 pontiac grand prix wont start and it says starting disabled due to theft system


Go through the steps to raise the theft alarm. The local dealer can guide you over the phone - usually after verification you're the rightful owner.

Jun 27, 2011 | 2005 Pontiac Grand Prix

2 Answers

1991 Dodge Shadow. When its warmed up and im driving it around, the engine just shuts off. I pull over, try to start it again and it wont turn over. So i wait 5 minutes and it'll start but 5 minutes later...


this is a typical Coolant Temp Sensor issue. the part is about $20 and can be done in a few minutes. I can further help if i knew which engine was in the car.

Apr 22, 2011 | 1991 Dodge Shadow

1 Answer

2004 landcrusier 100 series. glow plug light stays on all the time, although the glow plugs are not being supplied power. starts and runs ok.


THIS COMES ALL FROM "WAIT TO START" DO YOU WAIT TO START? IF NOT,THEN THE GLOW PLUGS ARE BUR'NT OUT,WHICH YOU WILL NOT NEED UNTIL FALL. OR MAYBE YOU'VE GOT IT HOOKED ON EITHER,STARTING FLUID,IN WHICH CASE,I SUGGEST YOU REPLACE THOSE GLOW PLUGS NOW.OR ELSE YOU'RE MOVING ON TO EVEN WORSE ISSUES.LET ME ASK YOU THIS,WHY ARE'NT THE GLOW PLUGS BEING DENIED POWER? AFTER ALL THEY START THE ENGINE? AFTER YOU INSERT THE KEY INTO THE SWITCH,WAIT TO START,LIGHTS UP.IF YOU'VE NOT WAITED UNTIL THAT WAIT TO START LIGHT GOES OFF,,,YOU'VE BURNT THE GLOW PLUGS UP.THE ONLY THING TO DO IS REPLACE THEM ALL.IF YOU'VE BEEN USING STARTING FLUID OR EITHER TO START YOUR ENGINE FOR A LONG PERIOD OF TIME,FORGET REPLACING THE GLOW PLUGS,BECAUSE YOUR ENGINE IS ADDICTED TO THE BOTTLE(EITHER) YOU MAY BE ONE OF THE LUCKY ONES,REPLACING THE GLOW PLUGS MAY RESOLVE YOUR ISSUES.BUT,WAIT TO START,,AIN'T NO JOKE. BEST OF LUCK TO YOU & YOURS!

Apr 08, 2011 | 2004 Toyota Land Cruiser

1 Answer

1995 dodge neon Rotates but will not start...engine code 55


Check to see if you have pulled on the crankshaft sensor and it has come away at the plug.And do the same at the coil pack.

Jul 28, 2009 | 1995 Dodge Neon

1 Answer

Proper installation instructions for Rocker Arm Installation 1998 Dodge 5.9 360.


locate v8 on crankshaft damper(147 degrees ATDC). rotate engine until v8 lines up with TDC mark on timing cover. install rocker arm and pivot assemblies and torque to 21 ft. lbs. wait 5 minutes before starting vehicle to allow lifters to bleed down correctly

May 19, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

My engine locked up in my siloutte


Using a socket and a ratchet/ breaker bar (socket size to get crankshaft pulley) Try rotating engine it should rotate, try to rotate 360 degrees a few times if it does the ENGINE IS NOT SEIZED. Contact if you need more help, Thanks for using FIX YA

Jan 16, 2009 | 1997 Oldsmobile Silhouette

Not finding what you are looking for?
1991 Honda Accord Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...