Question about Nissan Sentra

Open Question

Replace passenger side no fold mirror - Sentra Nissan Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: installing a Nissan Sentra Passenger Side Manual Non Folding Mirror.

had to install a driver side non folding mirror, fairly simply to say the least. There's a cover on the interior of the door, near the window, remove the cover, remove the 3 screws, need i believe a 10mm socket. If a power window, unhook the circuit. Replace new mirror.

Posted on Aug 25, 2008

  • 1 Answer

SOURCE: passenger side mirror

If you need to replace the entire mirror - it's a little involved. First you need to take the upper extension panel off from behind the mirror (black triangle) - just pull it of starting at the top. It will snap back on later. Next - remove the different screws holding the door panel in place (not the ones behind the mirror yet!) One is under the handle (pull it out and pull out the filler panel - small plastic thing that has a hole to pry it out). Then take off the rear red light - also pops off - and remove that screw. Finally - pick up the rubber filler where your fingers pull the door shut and remove these torx bolts.

Now is the tricky part. Snapp off the entire interior panel. It will pop off - but very difficult. It will sound like it is breaking! Start at the outer bottom corner - and use a door panel remover tool - check Amazon or E-bay - to keep from breaking things. Pull it out from all around the bottom and sides and then lift it up over the door lock. It good to have a friend help here. The panel will still be held on by a cable - that is your door release - leave it alone and let the panel hang by it (or better, put a box under it to rest on).

Now...remove the three bolts holding the mirror on - have a friend help hold the mirror while you do this or it will scratch your new car! Since the inner panel is off - you can also disonnect the mirror plus and remove it. It sounds silly - but the only reason to remove the door panel is to unplug it!

Get you new mirror and reverse the steps.

If you are just replacing the glass (non-heated) - get a replacement from the dealer. Adjust the mirror all the way to the inside and reach behind and pop it off. CAREFUL - put tape over the entire glass as it will likely break even more! Remove your connectors if heated - and replace (and reconnect) with your new glass. It just pops back on!

Replacing glass is easy - just be careful of cheap imitations on e-abay). And never use cheap flat glass on the passenger side! The DOT has special requirements for mirror glass - buy it from gmpartsdirect.com or your local dealer.

kb

Posted on Jan 08, 2009

  • 1986 Answers

SOURCE: How do I replace broken 2002 buick century passenger side mirror?

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

  • 1986 Answers

SOURCE: replace passenger side mirror on 2008 Impala

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

  • 1 Answer

SOURCE: How to replace passenger side mirror on 2007 Camry

To remove mirror pry off inside triangle panel(black) which exposes 3 nuts which are removed with socket wrench. Detach wire harness and pull out mirror assembly. To replace insert new mirror screws thru assigned holes and reconnect wire harness and tighten nuts to snug. Push inside triangle panel back into place and you're done! It's that easy.

Posted on Jan 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How d I swith passenger side mirror on a power mirror on a 2004 Jeep Grand Cherokee limited edition


no symptoms posted (broke glass or ???) can we be on same page?
"how do I switch," verb switch , the mirror as switches inside, too.

please say what that word means. switch and the failure.
1: remove and replace with new.
2: move right to left and left to right side.

why would you do that #2
fold away mirrors/ Export only (this is usa forum so..)
these,NASA grade mirrors are very complex... not just glass and plastic. heaters ,motors, memory , etc.

the FSM cover all tests for the mirror, including scan data.

ill quote the FSM now , 8 steps (just 1 fail,not heat, not memory failure or fold failure)
ONE MIRROR INOPERATIVE
(1) If the one inoperative mirror is on the passenger
side, go to Step 2. If the one inoperative mirror is
on the driver side, go to Step 3.
(2) Check if the passenger front door will lock and
unlock using the power lock switch on the driver side
front door. If OK, go to Step 3. If not OK, go to Step 6.
(3) Disconnect and isolate the battery negative
cable. Remove the trim panel from the front door.
Disconnect the 12-way mirror wire harness connector
from the door wire harness connector.
(4) Using two jumper wires, test the mirror as
shown in the Mirror Test chart (Fig. 2). If the mirror
tests OK, go to Step 5. If the mirror does not test
OK, replace the faulty mirror.
(5) Disconnect the 12-way door wire harness connector
from the door module connector receptacle.
Check all of the circuits of the door wire harness
between the connector for the mirror and the connector
for the door module for opens or shorts. If all of
the circuits are OK, replace the faulty door module.
If any of the circuits are not OK, repair the open or
shorted circuit(s) as required.
(6) Use a DRB scan tool and the proper Diagnostic
Procedures manual to test and repair the faulty Programmable
Communications Interface (PCI) data bus
communication between the two door modules.

(bar stool answer) all cars. mostly
pull door skins
unplug motor conn.
unscrew mirror base from door.
extract mirror,

Mar 07, 2015 | 2004 Jeep Grand Cherokee

2 Answers

Where to add side mirrors on a 58 ford Fairlane


I've had the same quandary with my 59 Ford Custom 300 and the more of them I've looked at, the more I've noticed it seems to be personal preference. Mine are currently positioned just to the side of dead center on the top and directly across from the hood cowl side to side. I've seen some positioned on the fender just ahead of the doors or even on the doors to about a third of the way down the fender. I'm getting ready to move mine rearward, I like the look. It's all your vision, my friend. Good luck!

Nov 23, 2012 | Cars & Trucks

1 Answer

How to replace passenger door side mirror 2012 ford flex


The related help links are mentioned below.Click the link below:---
---------How to remove rear view mirror metal foot?

http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-rear-view-mirror-metal.html


----------

power locks, power window and power mirror on the passenger side not working on Ford Windstar
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html


----How to Remove Outside Mirrors on Acura Integra?

http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-outside-mirrors-on-acura.html


-------Passenger side Folding Mirror is not operating? http://schematicsdiagram.blogspot.com/2011/12/passenger-side-folding-mirror-is-not.html

--------
These will help.
Thanks.



Nov 18, 2012 | 2012 Ford Flex SE Wagon 3.5L V6 6-speed...

1 Answer

2007 passenger folding mirror will not work


{: ) Have someone control the power fold buttons, while you check closely the passenger mirror. If you can feel or hear even a faint hum of the motor while commanded, try giving it a little help, but don't force it if you think it doesn't have enough power to extend or retract itself. The motor could be really stuck or inoperative.
Sometimes when the mirror has been accidentally or manually folded, it needs to be reset by just pressing on the fold buttons a few rounds and let the mirrors fold by itself. Like an exercise.
If you hear the humming noise whenever the fold buttons are pressed, we can assume that the circuit on that side is ok since it is responding electrically, and that a jammed or stuck mechanism is preventing it to move.
If you don't feel or hear any humming, as in totally no sign of response, then there will be additional considerations before deciding to go for a replacement mirror. You will need to confirm if the fault is on the wirings, a door module, or the mirror motor itself. A scan tool test may be recommended for effective diagnosis.
The power fold mirror can be serviced as an assembly. So, goodluck.

Aug 30, 2011 | 2005 GMC Yukon

1 Answer

Passenger mirror not folding in


Grab the passenger mirror with both hands. Fold the mirror all the way forward, all the way back and then back to the home position. Sometimes the mirror will get off track if it has been bumped or moved out of place manually.

Jun 04, 2010 | 2007 Chevrolet Tahoe

1 Answer

Electric mirrors (both sides) not returning to central position but folding all the way in/out. Is this something I can repair or fix myself?


Hello. You may or you may not have a repair to make. Let me explain. What you may be experiencing is a feature whereby you can fold the mirror in when in a tight spot. This function only occurs when the rocker switch is set in the middle, as opposed to the left which then allows you to control the driver's side mirror or the right which allows you to control the passenger side mirror. Try putting that power mirror rocker switch in different positions and see what happens, you can't break it.
That said, if indeed you can't get the power mirrors to behave properly then you will have to replace that rocker switch. Regards, Joe
PS please rate my answer. Thank you.

Jan 15, 2010 | 2000 Chrysler Grand Voyager

1 Answer

How do I replace the power side mirrors ( manual Fold) Driver Side and Passenger side


The small triangular shaped plastic panels that are on the inside of the window where the mirror is on the outside (closest to the front window) pop off and there are fasteners there.

Aug 06, 2009 | 2000 GMC Yukon XL

1 Answer

Installing a Nissan Sentra Passenger Side Manual Non Folding Mirror.


had to install a driver side non folding mirror, fairly simply to say the least. There's a cover on the interior of the door, near the window, remove the cover, remove the 3 screws, need i believe a 10mm socket. If a power window, unhook the circuit. Replace new mirror.

Jul 28, 2008 | 2005 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...