Question about 1989 Mazda 626

Open Question

Shoulder seat belts has stopped working. could it be a fuse or something else?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 Honda Accord The Dash Gauges, Instrument Panel, Power Window and Automatic Seat Belts are not working


Check your fuses and relays first. The radio fuse also controls the seat belt shoulder harnesses, dash clock, and lighter. Check all your fuses and replace any blown ones. There is a fuse panel in your engine bay and one on the driver's side under the dash near your door

Feb 25, 2013 | 1990 Honda Accord

1 Answer

91 honda ex, passenger front seat belt is not working and the light in the dash board keeps lit, I have check the fuses for it, and all the connection to the belt and it seems all intact...any advise?


Your 1991 model Accord has automatic front retracting shoulder belts and, more than likely, the power retractor motor has gone bad on the passenger side front. If the shoulder seat belt is not in the retracted position, up close against the seat, when the car is running, the seat belt light will stay lit on your dash. Have the seat belt motor inspected and replaced if necessary.

Oct 18, 2010 | 1990 Honda Accord

1 Answer

I keeping blowing the fuse that powers the shoulder belt and power windows. What is making that happen?


Most likely a short. Or a motor in the seat belts or windows that is being strained. More strain=more amps=blown fuse. try to spray Silicone spray in the track guides for the seat belts, and windows.

Aug 15, 2010 | 1988 Toyota Cressida

1 Answer

Center rear seat does not have a shoulder/lap seat belt


You should be able to go to the dealer and buy the center lap belts and can install them without having to by the seat just call your loacal dealer they can tell you how much thy are, less expensive than the seat.

Apr 21, 2010 | 2002 GMC Sierra 1500

2 Answers

1990 CAMRY - Automatic shoulder belt doesn't operate


right thinking, check the fuse then the relay.that's what it is most of the time.

Jul 14, 2009 | 1988 Toyota Camry

1 Answer

1995 nissan quest GXE: Power seat belts stopped working.


the passive restraints control module is behind the panel by the gas pedal.

The fuse is a 30 amp fuse taht also controls power window. in battery box under hood in front of battery. chart on cover.
then it goes through left hand circuit breaker which is behind leftkick panel above fuse panel I think. there are 2 circuit breakers next to each other.

May 22, 2009 | 1995 Nissan Quest

1 Answer

How do we fix front passenger side seat belt retractor on 1999 Ford Taurus? It will not pull out....


you may have to remove the bolt that holds the buckle to the floor. Try to push the belt into the retractor and see if it frees up.

I assume you are saying it is in the locked mode. It has an automatic lock mode for holding a child seat. When the belt is pulled all the way out, it goes into locking mode. You will hear it ratchet when the belt starts going back in.



Section 01-20A: Restraints, Active 1999 Taurus, Sable Workshop Manual
DESCRIPTION AND OPERATION Safety Belt, Lap/Shoulder The dual locking mode retractor on the shoulder belt portion of the combination lap/shoulder safety belt for the front seat passenger and rear seat outboard passengers operates in two ways:
  1. In the vehicle sensitive (emergency locking) mode, the shoulder belt retractor will allow the occupant freedom of movement, locking tight only on hard braking, hard cornering or impacts of approximately 8 km/h (5 mph) or more. The front and rear outboard seat belt retractors can also be made to lock by pulling/jerking on the belt.
  1. In the automatic locking mode, the shoulder belt retractor will be automatically locked and remain locked when the combination lap/shoulder safety belt is buckled and does not allow the occupant freedom of movement. This mode provides tight lap/shoulder belt fit on the occupant and on a child safety seat or infant carrier installation restraint.
  1. When the combination lap/shoulder belt is unbuckled and allowed to retract completely, the retractor will switch to the vehicle sensitive (emergency) locking mode.
sxh~us~en~file=ani_caut.gif~gen~ref.gif WARNING: REAR-FACING INFANT SEATS SHOULD NEVER BE PLACED IN THE FRONT SEATS.
The automatic locking mode must be used when installing a child safety seat on the front passenger seat and rear outboard seats where dual locking retractors are provided

Apr 21, 2009 | 1999 Ford Taurus

1 Answer

Problem with 1994 Escort Seat belts


Just bought a 95 escort same problem on passenger side. Mine was the door latch, it's covered with a rubber boot to make contact when shut. If the boot is wore out it makes contact all of the time causing it to stay in the shut door position. Being handy I cut a piece of plastic from a fast food place and fit it in between to break the contact when up. Belt moves as it should now.

Jul 03, 2008 | 1995 Toyota Celica

2 Answers

Electric retractable seat belt problem


check your fuses. there is also a lever next to te parking brake..make sure it's down

May 17, 2008 | 1988 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...