Try to find the adjustment screws ...usually there are 2 adjustment screws one to adjust up and down and the other left or right... This screws are usually located either on top or at the back of the headlight housing..
SOURCE: how to change a headlight light bulb on toyota prius 2006?
they are usually changed from inside the engine compartment. you should be able to gain access to the bulb behind each headlight bazel. the socket often has to be turned to remove it. be careful not to touch the new bulb with your fingers as that will shorten it's lifespan. you may have to remove the battery if the burnt out bulb is on that side.
Robert
Please take a moment to rate this solution... thanks
SOURCE: How do you disassemble toyota hiace 2006 dash?
Its easy, The only tool you need is a plastic lever tool. Or can be done with big head screw driver (but car for the trims for it can get damaged)
Lever both side vents out, then pull on the trim gently outwards. (long piece from glove box to the end of the radio before the instrumental dash panel) Then pull the main inturmental dash out towards you as well. There may by plugs connected to the front panel. Disconnect that and it exposes the digital meter, I think it then takes only 2 x 10m bolts and the dash is out.
SOURCE: Hi I have a Toyota Hiace 2006 model and can't seem
The rear washer and the front share the same water bottle in the front, if the rear only is not working the hose to the rear may be disconnected or the motor for the rear washers is bad, there are two motors on the bottle one for front one for the rear, make sure both are working.
SOURCE: change headlight bulb Toyota hiace 2008
Check for a UTube How To video first on replacing bulb
SOURCE: How to change belt tensioner on Toyota commuter hiace 2006 2.7lit petrol automatic
Ok the tensioner is mounted to the engine block the belt is spring loaded .The spring is inside the tensioner the pulley rides on the belt .This is called a preload .On most belt tensioner this is the correct spelling of tensioner don't know why they say this is wrong .
ON most tensioners their will be a point to move it in reverse of the tention of the spring move it back remove the belt remove the bolt holding down the tensioner to the block
I nstall new one reroute belt compress tensioner
1,061 views
Usually answered in minutes!
×