Hi,
If you've got oil on your spark plugs it's usually a sign of a cylinder-head gasket problem, or a piston rings problem.?
Neither of them are cheap to fix.
If you take it into the shop, they can do a compression test on each cylinder to see if there's a particular problem.
A good sign that it might be the head-gasket is getting water in the oil, which usually leaves a white/grey trace on the inside of the oil filler-cap.
If your engine has done a really high mileage, or it hasn't really been serviced properly, the rings are favourite.
You can't repair it, you can only do a major strip-down to replace the damaged parts.
Since it's a 12 year old car, I might be most economic to keep on running it as it is, for as long as it lasts & then junk it or sell it for spare parts.?
Best of luck.
SOURCE: The check engine light on my 2006 ford fusion s
It means you have an engine miss. Have the vehicle scanned. Autozone will do this for free.
SOURCE: 2006 Ford Fusion SEL - TPS
The TPS is an easy part to replace. It has 2 screws and 1 electric connector. It is about the size of a butane lighter and attaches to the metal airhorn.
There is only a slight adjustment possible for this part. One end has an elongnated slot for the screw. Just look at where the old part was adjusted and replace it that way. The only thing you need to watch is aligning the slot on the throttle shaft with the indentation on the TPS.
While you are replacing the part, disconnect the battery on the POS cable and this will reset the "check engine" light on the dash. Then reconnect and drive your car.
SOURCE: 2006 Ford Fusion. Left front door inside handle
This link is from the handle to the latch. The door panel has to be removed in order for this problem to be fixed. The linkage is inside the door panel, it is a small diamater metal rod called a link. If you do the job yourself be careful not to break the door panel. In a shop, the labor is 1 hour for the job & if any, parts will be a seperate charge.
SOURCE: 2006 Repair Manual Ford Fusion 1.4
autozone.com sign up its free then click on repair manuals you will find all of your info there....good luck
SOURCE: my 2006 ford fusion check engine light is on and
P0882 - TCM Power Input Signal Low, this is a transmission code, I recommend that you take it to a dealer or qualified transmission shop. Hope this helps.
Car not starting or turning over indicates towards multiple possibilities.
It can be issue with battery or weak battery. But if battery checks out ok, then
it can be starter issue or faulty alternator or problem with low fuel pressure
or no spark at spark plugs due to dirty spark plugs or faulty
ignition coil or injectors getting cracked or dirty and needs to be cleaned.
To confirm the problem, the basic troubleshooting is required.
Click this link below and follow the troubleshooting:------
http://technoanswers.blogspot.in/2012/02/car-starting-issues.html
---------
This will help.
Thanks.
60 views
Usually answered in minutes!
×