Question about 2006 Chevrolet Uplander

1 Answer

Where is the fusible link located on a 2006 chev uplander with a 3.5l

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 5,503 Answers

From what I can see, you only have one fusible link, and it starts at the under hood fuse block, is shown as gray with white stripe, and it turns into a red/black wire carrying power to the instrument panel fuse block.
It probably originates at where the battery cable red wire connects to the under hood fuse block.

Posted on Mar 09, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2006 Uplander Sometimes will not start

Mine was doing same ... Make sure your not touching the gas b4 vehicle is started ... It floods easily ... 

Posted on Feb 02, 2009

  • 383 Answers

SOURCE: were is the fuse panel located on a 2008 chev uplander?

thebassman: You have two fuse blocks. One is located in the engine compartment on the right hand inner fender. It is a large plastic box with a black cover. When you remove it you will see relays and fuses.
The other fuse block is on the right hand side of the car. When you open the front door, look at the side of the dash and you will see a cover which you can pull off. It will expose the fuse block.
I hope my answer is sufficient. Let me know if I was helpful by answering FIXYA's question.

Posted on Apr 20, 2009

honeymokey
  • 3113 Answers

SOURCE: fusible link 1979 monte carlo

At the starter!

Posted on May 23, 2009

  • 280 Answers

SOURCE: Need to knwo the location of the fusible link on a

http://www.motorcraftservice.com/pubs/content/~WOYEXD/~MUS~LEN/41/00exdog1e.pdf
There you go - goto the index of this PDF, find fuses p160 or something, theres a picture of the "distribution Box" right hand side of engine about 1/3 way back - thats where the links are.
Thumbs up please!!! Thanks.

Posted on Jan 25, 2010

  • 81 Answers

SOURCE: My keyless remote for my 05 Chev uplander won't

best thing to do would to take it to either the dealer or a car audio place that deals with alarms

Posted on Sep 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Relay fuse on a 2006 hyundai elantra


The relay will be marked fan low and fan high.

Jan 16, 2018 | Hyundai Cars & Trucks

1 Answer

I have a 2006 Chevy Uplander, 165,000 kms, started hesitating going from 1-2nd gear. On the highway, going 100 km/hr, would rev but not go faster. No Eng light. Only one TC light on. What's wrong?


run the fault codes
problem indicates a TCM problem or low transmission oil level.
as most chev transmissions are sealed with no dip stick, it may need a service by an accredited service shop or auto transmission specialist shop

Dec 24, 2016 | 2006 Chevrolet Uplander

1 Answer

2006 Chev Uplander. When I try to remote start this thing it will not start, tail light flashes once. I unhooked battery to clear codes but the yellow light come on again but not until I attempt to remote...


You need to find out what security code has set and then proceed. It sounds as if the ecm has lost ability to communicate with the other modules via the data bus.

Nov 06, 2014 | 2006 Chevrolet Uplander

1 Answer

How do tell if the rear air suspension system is working?


this is located on the axle and to the shell, the rife level sensor.
81zkolfl49l._sx463_-lnl2gu4ihoxszz5hfvvcpt4h-2-0.jpg

Feb 02, 2018 | 2006 Chevrolet Uplander

1 Answer

Why would the powerlocks on my 2006 Chev Uplander unlock on their own?


Hi Brenda, I believe one of the locking soloniods is sticking. That will cause the problem you are reporting. Regards John

Aug 11, 2012 | 2006 Chevrolet Uplander

1 Answer

2006 chev uplander lights blink at night


replace the head light switch, check the plug in at the switch they have a bad problem with the wiring getting hot at the plug in , chevy makes a repair kit to replace the plug with a new style....good luck

Dec 15, 2011 | 2006 Chevrolet Uplander

1 Answer

Cannot compress the cylinder on my rear brake chev uplander


it takes a special tool that screws cylinder back in this is how it adjusts out.

Jul 31, 2010 | 2006 Chevrolet Uplander

3 Answers

Change fuel filter in a 2006 Chevrolet Uplander


prev.gif next.gif Fuel Filter The fuel filter is part of the fuel tank module. (in the fuel tank)

It's kind of difficult to drop a fuel tank and replace the fuel tank module due to the weight and danger of gasoline catching fire or exploding.

Jul 19, 2010 | 2006 Chevrolet Uplander

1 Answer

2006 Uplander Sometimes will not start


Mine was doing same ... Make sure your not touching the gas b4 vehicle is started ... It floods easily ... 

Oct 10, 2008 | 2007 Chevrolet Uplander LS Minivan

Not finding what you are looking for?
2006 Chevrolet Uplander Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...