I have a Mitsubishi outlander 2007 my indicator and hazard light stopped working any idea what it could be check the fuses and bulbs all good

SOURCE: No rear brake light / turn signals on 2001 Chevy Cavalier

The problem is the turn signal/headlight/hazard switch assembly on the steering column which the brake light wiring runs through. The part is easy to change and cost about $50 at most parts stores

SOURCE: Left rear brake light stopped working but bulb and fuses are OK.

take the bulb back out have someone sit in car apply brake get your self a circuit tester and check to see if this circuit is carrying efficient 12 volt current! some times in cold weather these bulbs get hot with long period of breaking and when released condensate and rust begins and you get what you have perhaps bad socket! this would be a ideal location to begin and probably end,

SOURCE: Left rear brake light stopped working but bulb and fuses are OK.

These are Dual Function Bulbs. They control the Parking Lights and the Brake Lights. This Bulb is Burnt out on the Brake Coil inside the Bulb. I have actually seen Bulbs that were Bad But you could not Tell by jast looking at them. It should be fine with a New Bulb. Please Rate My Response! Thanks!

steven martin

• 117 Answers
• Posted on Apr 07, 2009

SOURCE: brake lights wont work

Check the brake light switch which is located above the foot pedals on a metal bracket.

SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards

I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!