Question about 1992 Mitsubishi Galant

1 Answer

1992 Mitsubishi lancer GLXI check engine light sensor appear

I had this problem on my car after starting the engine for 5 minutes check engine appears light on and off , then when it goes off after shifting the gear to primera hitting to 20 rpm check engine goes on and shutting off the engine then same sequence happen again, would it be the computer box? need suggestion.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 3,267 Answers

Well the sensors are reporting a failure in the engine/transmission. So either they are right or wrong has to be assessed by the nature of the alarms or sensor faliure, but the problem remains, hence if all primary steps of investigation start by hooking up to a PC specially built to rectify such problems. This facility is available at most of the gas service stations/centers..................sodeep

Posted on Jul 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Not shifting


Any transmission trouble code will put the trans in second gear
and it won\'t shift.
Key on-off-on-off-on without starting the engine will illuminate
the check engine light .It will flash out the codes.Should see a 55
code ,5 flashes,a pause then 5 more. Any codes other than 12 and
55 need recorded for further diagnnosis.
I was thinking that turning the key on and opening the throttle wide
open 4 times within 5 seconds (engine off)clears tranny codes,not sure about that tho. You might try it then drive it and see if it shifts,although
as soon as the malfunction happens again it will go back into limp mode.
Tranny slipping or a slow shift or converter lock up malfunction along
with many other things will trigger this.

Mar 16, 2013 | 1999 Plymouth Grand Voyager

1 Answer

I have Grand Cherokee 1995 6 cylinder,I am facing starting problem now, in morning and if my jeep is in parking 4 to 5 hours,and I need to start the ignation my jeep does't start its take time 20 to 30...


Your ECU is going bad and needs to either be replaced or repaired. That 'no check engine light for 20-30 minutes' is a common problem that tells it's an ECU problem.The ECU won't power the fuel pump and other relays until the check engine light illuminates on the dash.

Jan 15, 2011 | 1995 Jeep Grand Cherokee

1 Answer

I have a 2004 concorde 2.7 liters , i just washed the car , suddenly check engine light appears out , the car shifts fine within the early few minutes but later it wont shift to 3rd it stay on 2nd gear,...


Could be water that touched one of your electronics that makes your transmission having problems try to dry the Transmission electronic connectors with low air pressure and see whats happens.Good luck

Dec 13, 2010 | 2004 Chrysler Concorde

2 Answers

Hi my plymouth 98 after start engine the first time in the morning the light advise engine service soon iluminate on the dashport the engine running with a light vibration for 3 minutes at the end is...


When light is on, take it to some place like autozone, let them do a code reading, they will do this service for free, get back with us the the trouble code number, so we can help you. This way you know what's going on, so it don't damage another sensor.

Aug 10, 2010 | 1998 Plymouth Voyager

1 Answer

I have 1995 Mits Lancer glxi matic. I observed that at normal idle or running condition, the engine rpm is slowly, slowly dropping to zero. Im just pressing the gas in order to keep running. otherwise will...


Try checking the codes. You can do this at part stores like auto zone for free. It might be the maf sensor or if it says lean o2 sensor than it's the fuel filter.

Jun 29, 2010 | Mitsubishi Lancer Cars & Trucks

2 Answers

Hi..where can i download repair manual for lancer GLXi 2005


Hi,you can download the manual for your mitsubishi at www.manualsonline.com,www.manualnguide.com and www.mitsubishi.com. please don't forget to rate this solution positively Thanks and good luck

Apr 19, 2010 | 2005 Mitsubishi Lancer

Not finding what you are looking for?
1992 Mitsubishi Galant Logo

687 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...